48344
97
Zoom out
Zoom in
Previous page
1/112
Next page
97
Unit does not turn on
when power operation
switch is pressed.
No sound is produced
from the speakers.
No treble sound is
produced, or the position of
the instruments is unclear.
A source other than the
desired one is heard.
Hissing sound is heard in
FM programs.
Hissing sound is heard in
MW programs.
Humming sound is heard
in MW programs.
Total numbers of tracks
not displayed when disc is
loaded.
Nothing happens when
operating buttons are
pressed.
Disc stops in the middle of a
track and will not play properly.
Sound is broken.
Humming sound is heard
when disc is played.
Check the following before assuming there is a problem with the system.
1. Are connections properly made?
2. Is the system being operated as explained in the operating instructions?
If the system does not seem to be operating properly, check as shown on the table below.
If none of these checks apply to the problem, the system may be malfunctioning.
Disconnect the power cord immediately and contact the store from which this unit was purchased.
Symptom Cause Countermeasure
General
Tuner-amplifier
CD player
Power cord is not plugged into a power
outlet.
VOLUME control is turned down.
Headphones are connected.
Speaker cords are not securely
connected.
Muting is on.
Speaker polarities (Œ and œ) are
inverted.
Function is not properly set.
Antenna direction is poor.
Signals from the broadcast station are
weak.
Noise from a TV or interference from a
broadcast station.
Signals on the power cord are being
modulated by the power source
frequency.
Disc is loaded upside-down.
Disc is dirty.
Disc is not of the specified type.
Disc is loaded upside-down.
Foreign object on disc tray.
Disc is dirty.
Disc is scratched.
Dirt, fingerprint, spittle, etc, on disc.
Disc is scratched.
Player is in an unstable place or a
place that vibrates strongly.
Signals on the power cord are being
modulated by the power source
frequency.
Plug the power cord securely into an
outlet.
Set the control to an
appropriate position.
Disconnect the headphones.
Connect securely.
Turn off Muting.
Connect the speaker cords properly.
Set the desired function using the
FUNCTION button.
Change the direction of the antenna.
Install an outdoor antenna.
Turn the TV off.
Change the direction of the loop antenna.
Install an outdoor antenna.
Insert the power cord in the opposite
direction.
Install an outdoor antenna.
Reload the disc.
Clean the disc.
Replace with a disc of the specified
type.
Reload the disc.
Remove the disc and the foreign
object.
Clean the disc.
Replace with an unscratched disc.
Clean the disc.
Replace with an unscratched disc.
Place the player in a stable place
with no vibrations.
Insert the power cord in the opposite
direction.
• TROUBLESHOOTING
English
Protector circuit
The HCU-R30E is equipped with a high speed protector circuit.
This circuit protects internal parts from being damaged by strong currents generated in the unit should the unit be
operated when the speaker terminals are incompletely connected or short circuited.
If this protector circuit is activated, a relay sound is produced, the output to the speakers is interrupted, and the
indicator blinks rapidly to indicate that there is a problem. If this should happen, unplug the power cord, and contact
your store of purchase.
The unit may not operate properly due to such external influences such as lightning or static electricity. If this
happens, either turn off the power with the power operation switch or unplug the power cord, wait approximately 5
seconds, then plug the power cord back in.
97


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi AXF100WUN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi AXF100WUN in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info