© Hikvision
White light of the camera flashes when alarm happens. Flashing Duration, Flashing
Frequency, and Brightness are configurable on Flashing Alarm Light Output page:
Configuration > Event > Basic Event
Notes:
Before using the function, go to Configuration -> System -> Maintenance -> System
Service to enabled white light in advance.
The function is only supported by certain camera models.
Audible Warning
Built-in speaker or connected external speaker plays warning sound when alarm
happens. Sound Type and Alarm Times are configurable on Audible Alarm Output page:
Configuration > Event > Basic Event
Notes:
Before using the function, go to Configuration -> Video/Audio -> Audio to enabled
built-in speaker in advance.
The function is only supported by certain camera models.
Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
Notes:
To trigger an alarm output when an event occurs, refer to Section 5.2.4 Configuring
Alarm Output to set the alarm output parameters.
The function is only supported by certain camera models.
Trigger Recording
Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section
5.1.1 Configuring Recording Schedule for settings the recording schedule.
The function is only supported by certain camera models.
5.2.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
