816435
7
Zoom out
Zoom in
Previous page
1/196
Next page
English
7
WARNING
Fuel is easy to ignite or get explosion or inhale fumes, so
that pay special attention when handling or lling fuel.
Do not smoke or allow smoking near fuel or the unit/
machine or while using the unit/machine.
Wipe up all fuel spills before starting engine.
Store unit/machine and fuel in area where fuel vapors
cannot reach sparks or open ames from water heaters,
electric motors or switches, furnaces. etc.
When using the unit in dry areas, make sure that re
extinguishing equipment is readily available.
If you shut o the engine for refueling, make sure the unit
has cooled down before adding fuel.
Blowing safety
Operate unit/machine only at reasonable hours – not
early in the morning or late at night when people might be
disturbed. Comply with times listed in local ordinances.
Usual recommendations are 9:00 a.m. to 5:00 p.m.,
Monday through Saturday.
Never direct discharge of air toward bystanders nor allow
anyone near the area of operation. Use care in directing
discharge to avoid glass enclosures, automobiles, etc.
Check the work area and surroundings for empty cans,
metal pieces and other obstructions which could cause
injury, accident or damage. If there are any of these
objects in the area, remove them in advance.
Stay alert for uneven sidewalks, holes in terrain or other
unstable condition when using the tool.
Take all possible precautions when leaving the tool
unattended such as stopping the engine.
Never operate the tool without blow pipes or other
protective device in place. (If so equipped.)
Keep others including children, animals, bystanders and
helpers outside the 15 m hazard zone. Stop the engine
immediately if you are approached.
Please exercise caution as engine startup may be
delayed after pulling the starter handle.
Always keep the engine on the right side of your body.
Keep rm footing and balance. Do not over-reach.
Losing your balance during work may lead to an injury.
Keep all parts of your body away from the mu er when
the engine is running.
Always carry a rst-aid kit when operating any power
equipment.
Avoid prolonged use at low speed range in which
vibration is high. Doing so may result in engine damage.
When relocating to a new work area, or inspecting,
adjusting or exchanging the unit's accessories, etc., be
sure to shut o the machine.
Never place the machine on the ground when running.
If you accidentally bump or drop the unit, inspect it
immediately to make sure there are no damage, cracks
or deformations.
If the tool is operating poorly and produces strange noise
or vibrations, turn o the engine immediately and ask
your dealer to have it inspected and repaired.
Continued use under these conditions could lead to
injury or tool damage.
Use in accordance with local laws and regulations.
Loosen deposits with a rake or a broom before starting
any exhaust or vacuum work.
WARNING
Work from ladders or high place (such as roofs) is
prohibited and could result in severe injury.
Maintenance safety
Maintain the unit/machine according to recommended
procedures.
Disconnect the spark plug before performing
maintenance except for carburetor adjustments.
Keep others away when making carburetor adjustments.
Use only genuine HiKOKI replacement parts as
recommended by the manufacturer.
CAUTION
Do not disassemble the recoil starter. There is a
possibility of personal injury with recoil spring.
WARNING
Improper maintenance could result in serious engine
damage or in serious personal injury.
Transport and storage
Carry the unit/machine by hand with the engine stopped
and the mu er away from your body.
Allow the engine to cool, empty the fuel tank, and secure
the unit/machine before storing or transporting. Failure to
do so may result in re or accidents.
Empty the fuel tank before storing the unit/machine. It is
recommended that the fuel be emptied after each use. If
fuel is left in the tank, store so fuel will not leak.
Store unit/machine out of the reach of children.
Clean and maintain the unit carefully and store it in a dry
place.
Make sure engine switch is o when transporting or
storing.
You have to secure the machine during transport to
prevent loss of fuel, damage or injury.
If a warning label cannot be read, peels o or becomes
indistinct, replace it with a new one. To purchase new
labels, contact HiKOKI Authorized Service Centers.
If situations occur which are not covered in this manual,
take care and use common sense. Contact HiKOKI
Authorized Service Centers if you need assistance.
SPECIFICATIONS
The SPECIFICATIONS of this machine are listed in the table
on page 192.
NOTE
All data subject to change without notice.
ASSEMBLY PROCEDURES
WARNING
Make sure the engine is turned o /stopped and not hot
before assembly.
Blow pipes to main body (Fig. 3)
Inspect the main body and accessories.
Connect straight pipe (I) securely. Align projection (8) in
straight pipe with groove (9) on blower housing and slide the
pipe into the blower housing.
Rotate the pipe clockwise to lock it into place.
Nozzle to straight pipe (Fig. 4 - 5)
[RB27EAP]
Align groove (9) on the conic pipe (J) and projection (8)
on straight pipe (I) and rotate the conic pipe in place.
[RB27EP]
Align groove (9) on the Fan-Headed pipe (P) and
projection (8) on straight pipe (I) and rotate the Fan-
Headed pipe in place.
NOTE [RB27EP]
(Optional)
Vacuum attachment is o ered as an optional kit which
converts the hand-held blower into a vacuum cleaner.
For installation see Vacuum kit RB-HVA (RB27E/EP)
manual.
(Safety future)
If you try to open the guard net (K) when engine is
running, it will automatically stop the engine. (Fig. 1)
But never try to open the guard net (K) when engine is
running even with this future, otherwise serious personal
injury may occur.
000BookRB27EAP.indb7000BookRB27EAP.indb7 2018/12/149:11:252018/12/149:11:25
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hikoki RB27EP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hikoki RB27EP in the language / languages: All languages as an attachment in your email.

The manual is 19.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info