816221
15
Zoom out
Zoom in
Previous page
1/228
Next page
English
15
Symptom Possible cause Remedy
Tool doesn’t run Concrete dust has accumulated on
the terminals of the battery
installation compartment as well as
on the battery sliding grooves.
Clean off the accumulated concrete
dust with an air gun or a dry cloth.
Tool suddenly stopped Tool was overburdened Remove the cause of the
overburdening.
Battery or tool is overheated. Allow the tool and battery to
thoroughly cool.
Tool bits
-can’t be attached
-fall off
The shape of the attachment portion
doesn’t match For the SDS-max shank type, use a
bit with a diameter that is within the
designated range.
Concrete can’t be smoothly
demolished. The bit is worn Sharpen or replace with a new bit.
Battery cannot be installed. Attempting to install a battery other
than that specified for the tool. Please install a multi volt type battery.
2023/07/20 17:28:42Stylesheet: EU Version: 2023.6.21
H3641DA_C99749471_308_EU
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hikoki H3641DA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hikoki H3641DA in the language / languages: All languages as an attachment in your email.

The manual is 3.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info