816442
9
Zoom out
Zoom in
Previous page
1/212
Next page
English
9
WARNING
Antivibration systems do not guarantee that you will not
sustain Hand-Arm Vibration Syndrome or carpal tunnel
syndrome.
Therefore, continual end regular users should monitor
closely the condition of their hands and ngers. If any
of the above symptoms appear, seek medical advice
immediately.
Long or continuous exposure to high noise levels may
cause permanent hearing impairment. Always wear
approved hearing protection when operating a unit/
machine.
If you are using any medical electric/electronic devices
such as a pacemaker, consult your physician as well as
the device manufacturer prior to operating any power
equipment.
Unit/machine safety
Inspect the entire unit/machine before each use and
after dropping or other impacts. Replace damaged parts.
Check for fuel leaks and make sure all fasteners are in
place and securely tightened.
Replace parts that are cracked, chipped or damaged in
any way before using the unit/machine.
Make sure the side case is properly attached.
Make sure the chain brake is working properly.
Keep others away when making carburetor adjustments.
Use only accessories as recommended for this unit/
machine by the manufacturer.
Never let the chain strike any obstacle. If the chain
makes contact, the machine should be stopped and
checked carefully.
Make sure the automatic oiler is working. Keep the oil
tank lled with clean oil. Never let chain run dry on the
guide bar.
All chain saw service, other than the items listed in the
operator’s/ owner’s manual, should be performed by
HiKOKI Authorized Service Centers. (For example,
if improper tools are used to remove the ywheel or if
an improper tool is used to hold the ywheel in order to
remove the clutch, structural damage to the ywheel
could occur and could subsequently cause the ywheel
to burst.)
WARNING
Never modify the unit/machine in any way. Do not use
your unit/machine for any job except that for which it is
intended.
Tampering with the engine voids the EU type approval of
this engine.
Never use chain saw without any safety equipment or
that has faulty safety equipment. It could result in serious
personal injury.
Using guide bar/chain other than recommended by the
manufacturer which are not approved, could result in a
high risk of personal accidents or injury.
Fuel safety
Mix and pour fuel outdoors and where there are no
sparks or ames.
Use a container approved for fuel.
Do not smoke or allow smoking near fuel or the unit/
machine or while using the unit/machine.
Wipe up all fuel spills before starting engine.
Move at least 3 m away from fueling site before starting
engine.
Stop engine and let it cool for a few minutes before
removing fuel tank cap.
Store unit/machine and fuel in area where fuel vapors
cannot reach sparks or open ames from water heaters,
electric motors or switches, furnaces, etc.
WARNING
Fuel can be easily ignited and easily inhaled, pay special
attention when handling.
Cutting safety
Do not cut any material other than wood or wooden
objects.
For respiratory protection, wear an aerosol protection
mask when cutting the wood after insecticide has been
applied.
Keep others including children, animals, bystanders
and helpers outside the hazard zone. Stop the engine
immediately if you are approached.
Hold the unit/machine rmly with the right hand on the
rear handle and the left hand on the front handle.
Keep rm footing and balance. Do not over-reach.
Keep all parts of your body away from the mu er and
cutting attachment when the engine is running.
Keep guide bar/chain below waist level.
Before felling a tree, the operator must be accustomed to
the sawing techniques of the chain saw.
Be sure to pre-plan a safe exit from a failing tree.
While cutting, hold the unit/machine rmly with both
hands with thumb rmly locked around front handle, and
stand with feet well balanced and your body balanced.
Stand to the side of the guide bar when cutting - never
directly behind it.
Always keep the spiked bumper facing forward a tree,
because the chain may suddenly be drawn into a tree, if
so equipped.
When completing a cut, be ready to hold up the units as it
breaks into clear, so it will not follow through and cut your
legs, feet or body, or contact an obstruction.
Be alert against kickback (when chain saw kicks up and
back at operator). Never cut with the nose of the guide
bar.
When relocating to a new work area, be sure to shut o
the machine and ensure that all cutting attachments are
stopped.
Never place the machine on the ground when running.
Always ensure that the engine is shut o and any cutting
attachments have completely stopped before clearing
debris or removing grass from the cutting attachment.
Always carry a rst-aid kit when operating any power
equipment.
The mu er gets very hot during and after use. This also
applies during idling.
Be aware of the re hazard, especially when working
near ammable substances and/or vapours.
WARNING
The exhaust fumes from the engine are hot and may
contain sparks which can start a re. Never start the
machine indoors or near ammable material.
Maintenance safety
Maintain the unit/machine according to recommended
procedures.
Disconnect the spark plug before performing
maintenance except for carburetor adjustments.
Keep others away when making carburetor adjustments.
Use only genuine HiKOKI replacement parts as
recommended by the manufacturer.
CAUTION
Do not disassemble the recoil starter. There is a
possibility of personal injury with recoil spring.
WARNING
Improper maintenance could result in serious engine
damage or in serious personal injury.
Transport and storage
Carry the unit/machine by hand with the engine stopped
and the mu er away from your body.
Allow the engine to cool, empty the fuel tank, and secure
the unit/machine before storing or transporting.
Empty the fuel tank before storing the unit/machine. It is
recommended that the fuel be emptied after each use. If
fuel is left in the tank, store so fuel will not leak.
000BookCS40EA.indb9000BookCS40EA.indb9 2019/01/2512:32:242019/01/2512:32:24
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hikoki CS40EA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hikoki CS40EA in the language / languages: All languages as an attachment in your email.

The manual is 41.55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info