816372
14
Zoom out
Zoom in
Previous page
1/236
Next page
14
English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
Symptom Possible cause Remedy
Tool doesn’t run No remaining battery power Charge the battery.
Battery isn’t fully installed. Push the battery in until you hear a click.
Tool suddenly stopped Tool was overburdened Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Battery or tool overheated Allow the tool and battery to thoroughly cool.
The trigger switch was held down for
5 minutes or more. This is not a malfunction.
The motor was automatically stopped to
prevent failure of the tool.
Saw blade
- can’t be attached
- fall o
The shape of the attachment portion doesn’t
match Use the appropriate blade
The blade’s attachment hole is worn Replace with a new blade.
Switch can’t be pulled Lock-o button is pushed in Release the Lock-o button.
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
The trigger switch is being pulled only
slightly. This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Blade wears out too
quickly. Proper machine oil not used when cutting
metallic materials Use machine oil (turbine oil, etc.)
Too much applied pressure during operation During operation, lighten the applied
pressure.
Unable to properly cut. Blade is inappropriate for the quality and
thickness of the material to be cut Use the proper blade
Blade is too short for the length of the
material to be cut
Blade is worn, degraded or damaged Replace with a new blade.
Battery cannot be installed Attempting to install a battery other than that
speci ed for the tool. Please install batteries that are multi volt or
BSL18xx series.
0000BookCR18DBEU.indb140000BookCR18DBEU.indb14 2022/12/0115:48:142022/12/0115:48:14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hikoki CR18DB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hikoki CR18DB in the language / languages: All languages as an attachment in your email.

The manual is 10.31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info