700139
22
Zoom out
Zoom in
Previous page
1/32
Next page
22
INTERCONNECTION EXAMPLE
5-channel-mode: 2 x Stereo-System (Front & Rear) + 1 x Subwoofer
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION
Connect the RCA lineouts of the head unit with the RCA jacks LINE IN of the amplier with appropriate high-value RCA cables.
If your head unit is equipped with a separate SUB OUT use this for the CH5 inputs.
Connect the front speakers with SPEAKER OUTPUT + CH 1 - / + CH 2 -, rear speakers with SPEAKER OUTPUT + 3CH - / + 4CH -
Ensure that the total impedance load of each speaker is not lower than 2 ohms.
Connect the subwoofer with + SUB OUTPUT -. Ensure that the total impedance load of the subwoofer is not lower than 1 ohm.
Too low impedance cause high temperature and will shut down the amplier operation.
INPUT MODE SWITCH
Select the 5CH position on the INPUT MODE switch. If there are only two RCA stereo audio cables from the head unit available,
connect the CH1/2 and CH3/4 RCA line inputs and select the 4CH position. If you have only one RCA stereo cable, connect the
CH1/2 line inputs an select the 2CH position.
CROSSOVER SETTINGS CH1/2 & CH3/4
When using bigger speakers (more than 20cm) set the X-OVER switch to the FULL position (Full Range Signal).
When using smaller speakers (8.7cm - 16cm) set the X-OVER switch to the HP position (Highpass Mode) to avoid any
damage by lower frequencies on the speakers. The cut-off frequency is adjustable with the HP controller and should be set
between 60Hz to 150Hz, depending on the size of the speakers.
The LP controller from CH3/4 is not in use in this interconnecting example.
LEVEL CONTROLLER CH1/2 & CH3/4 & CH5
Turn the LEVEL controller of the amplier to the MIN position.
Turn the volume controller of the head unit to 80 - 90% of its full setting.
Turn the LEVEL controller clockwise until you hear some distortion.
Then turn back the LEVEL controller slightly until you hear a cleaner sound.
BASS BOOST CONTROLLER CH5
The BASS BOOST controller is continuously adjustable from 0dB bis +18dB.
Use this controller carefully.
LP CONTROLLER CH5
The LP (low pass) controller is for the adjustment of the Cut-Off-Frequency, which should be between 60Hz and 100Hz,
depending on the size of the subwoofer.
SUB SONIC CONTROLLER CH5
The SUB SONIC controller (Subsoniclter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid a
mechanical and electrical overloading on the subwoofer. The cut-off frequency is adjustable from 15 to 55 Hz and depends
on the size of the subwoofer. If this controller is set higher than the LP controller no audio is hearable.
BASS REMOTE CH5
The enclosed BASS REMOTE CONTROLLER adjusts the bass-level on the subwoofer channel CH5 e.g. from the drivers seat.
Please use only the enclosed bass remote controller and cable.
Connect the stereo RCA output (FL/FR, RL/RR and SUB OUT)
of the head unit with LINE IN CH1/2, CH3/4 and CH5 SUB IN
of the amplier.
HP or FULL
5CH
Loudspeaker
L & R, front
each 2 – 8 Ohms
Loudspeaker
L & R, rear
each 2 – 8 Ohms
POWER INPUT
FUSE
SPEAKER OUTPUT
BRIDGED
PROTECT
POWER
LP/BPFULLHP
HP/BP LP
CH2CH1
LEVEL
INPUT
X-OVER
CH3/CH4
50Hz 250Hz 150Hz 4kHz
GND +12VREM
5CH
2CH
INPUT MODE
BRIDGED
CH4CH3
ARX5005
LEVEL
MIN MAX
FULLHP
X-OVER
CH1/CH2
HP
50Hz 4kHz
LEVEL
MIN MAX
MIN MAX15Hz 55Hz 0dB 18dB
SUB OUTPUT
4CH
35Hz 150Hz
HI
LOW
OFF
ON
CH3
CH4
CH1
CH2
CH5
BASS LEVEL
CONTROLLER
CH5
LEVELSUB SONIC BASS BOOST CH5LP
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
LINE IN SUB IN
BLUE / WHITE
LOG0
Subwoofer
1 – 8 Ohms
Connect Bass Level
Controller with the
enclosed cable
POWER INPUT
FUSE
SPEAKER OUTPUT
GND +12VREM
ZRX8805
SUB OUTPUT
CH5
PROTECT
POWER
LP/BPFULLHP
HP/BP LP
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
LEVEL
INPUT
X-OVER
CH3/CH4
50Hz 250Hz 150Hz 4kHz
5CH
2CH
INPUT MODE
LEVEL
MIN MAX
FULLHP
X-OVER
CH1/CH2
HP
50Hz 4kHz
LEVEL
MIN MAX
LEVEL
MIN MAX
SUB SONIC
15Hz 55Hz
BASS BOOST
0dB 18dB
CH5
4CH
LP
35Hz 150Hz
CH3
CH4
LINE IN
CH1
CH2
CH5
SUB IN
BRIDGED
CH2CH1
BRIDGED
CH4CH3
BASS LEVEL
CONTROLLER
HI
LOW
OFF
ON
BLUE / WHITE
LOG0
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics ZRX8805 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics ZRX8805 in the language / languages: English, German as an attachment in your email.

The manual is 7,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info