700150

Hifonics X4-Andromeda Manual

21
Zoom out
Zoom in
Previous page
1/28
Next page
WHITE
BLUE
BATT +12V
GND
REM
FUSE
POWER INPUT
LOGO BADGE
SPEAKER OUTPUT
MONO BRIDGED
– CH4 + – CH3 +
MONO BRIDGED
– CH2 + – CH1 +
REMOTE
CH1
CH2
CH3
CH4
LINE INPUTS
CH1/2
CH3/4
BALANCED
INPUTS
STEREO
MONO
12dB
24dB
INPUT MODE
4CH 2CH
LOW PASS
LOW PASS
HIGH PASS
HIGH PASS
X-OVER MODE CH1/2
X-OVER MODE CH3/4
LP/BP FULL HP
LP/BP FULL HP
POWER
PROTECT
L
R
BASS BOOST
BASS BOOST
LEVEL
LEVEL
CH1/2 CH1/2
CH3/4 CH3/4
LINE OUTPUT
SUMMED CH1/2/3/4
FULL RANGE
21
OPERATING INSTRUCTIONS
INTERCONNECTION
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables. If
a separate SUB OUT from your headunit is available, use this for the LINE INPUT CH3/4 on the amplifier.
• Connect the speakers with SPEAKER OUTPUT + CH 1 - and + CH 2 -, and the subwoofer with the
SPEAKER OUTPUT CH3/4 + Mono Bridged - of the amplifier.
• Ensure by any means, that the total impedance load channel (CH1 & CH2) is not lower than 1 ohms and the total impedance load of
the bridged mode (CH3 & CH4) is not lower than 2 ohms. Too low impedance cause high temperature and will shut down the
amplifier operation.
INPUT MODE SWITCH
• Check the notes on page 20.
CROSSOVER SETTINGS CH1/2 (STEREO SYSTEM)
• Check the notes on page 20.
BASS BOOST CONTROLLER CH1/2 (STEREO SYSTEM)
• The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
LEVER CONTROLLER CH1/2 (STEREO SYSTEM) & CH3/4 (SUBWOOFER)
• Check the notes on page 20.
CROSSOVER SETTINGS CH3/4 (SUBWOOFER)
• In the mono/subwoofer mode the X-OVER switch must set to the LP/BP position (Lowpass/Bandpass mode), thereby the higher
frequencies will be eliminated. The cut-off frequency ist adjustable with the LOW PASS controller and should be set between
60 to 100 Hz, depending on the size of the subwoofer.
• In the lowpass mode (LP/BP) the HIGH PASS controller works also as subsonicfilter, that eliminates the ultra-low, not hearable and
harmful frequencies to generate a bandpass signal (Bandpass mode). The subsonic frequency should be set between 15 to 50 Hz,
depending on the size of the subwoofer. NOTE: If this value is higher than the lowpass setting, no sound is hearable.
• Push the STEREO 12 dB / MONO 24 dB push button to position MONO 24 dB, thereby the slewrate of the lowpassfilter on CH3/4 will
be advanced to 24db/octave.
BASS BOOST CONTROLLER CH3/4 (SUBWOOFER)
• The BASS BOOST controller adjusts the bass enhancement between 0db and +18dB.
• A too high bass boost may cause clipping/distortion and damage on the loudspeakers and also may harm your hearing abilities.
Use this controller carefully!
BASS REMOTE CH3/4 (SUBWOOFER )
• The enclosed BASS REMOTE Controller adjusts the bass-level e.g. from the driver’s seat of the Subwoofer on CH 3/4.
Please use only this enclosed bass remote controller and cable.
EXAMPLE 3-Channel Mode: 1 x Stereo System & 1 x Mono Subwoofer bridged
Connect the bass remote
controller and the
remote terminal on the amplifier
with the enclosed cable.
RR RL
Connect the stereo RCA output (FL/FR & RL/RR opt.
SUB OUT) of the headunit with LINE INPUTS CH1/2 and
CH3/4 of the amplifier
Speaker
left
1 – 8 Ohms
Speaker
right
1 – 8 Ohms
FL FR
Subwoofer
2 – 8 Ohm
Switch position CH1/2 = HP or FULL
Switch position CH3/4 = LP/BP
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics X4-Andromeda at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics X4-Andromeda in the language / languages: English, German as an attachment in your email.

The manual is 3,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info