169037
14
Zoom out
Zoom in
Previous page
1/20
Next page
18
4-Channel-Mode Stereo Front- and Rearsystem
RCA & Speaker wiring:
• Connect the LINE INPUT of the amplifier to the head unit line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT/ - CH1 + and - CH2 + and - CH3 and -
CH4 +) of the amplifier.
• The minimum final speaker impedance must not be lower than 2 Ohms per channel. Too low speaker loads result in too high
heat dissipation and may cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal
X-Over Switch CH1/2 & CH3/4
• For bigger speaker systems (Ø 20cm), set the switch to FULL-position (FULL RANGE mode).
• For smaller speaker systems (Ø 8.7cm - Ø16cm), set the switch to HP-position (HIGH PASS mode).
The cut-off frequency can be selcted by the HI PASS-contoller.
• In this configuration the LOW PASS-controller is not required.
Level CH1/2 & CH3/4
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
Bass EQ CH1/2 & CH3/4
• This controller should be set to 0dB-position.
Bass Remote
• The provided Bass Remote is not required in this configuration.
Speaker & RCA Connections
Connect RCA outputs (CH1/2 and CH3/4)
of the head unit with LINE INPUT
(CH1/2 and CH3/4) of the amplifier.
Speakers CH1
2 - 8 Ohm
Speakers CH2
2 - 8 Ohm
FUSE
GND REM BATT+ 12V
POWER INPUT
SPEAKER OUTPUT
+ CH 3 – + CH 4 –
+ MONO BRIDGED –
+ CH 1 – + CH 2 –
Speakers CH3
2 - 8 Ohm
Speakers CH4
2 - 8 Ohm
Caution!
Do not connect speaker (-) to the ground or vehicle's chassis.
14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics txi5400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics txi5400 in the language / languages: English, German as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info