741687

Hendi 273876 Manual

6
Zoom out
Zoom in
Previous page
1/64
Next page
6
EN
6
Instruction for installation
Attention: Make sure again all the electrical power
system circuit is CLOSED and the switch (5) of the
appliance is at the OFF (0) position.
A) Installation of the mounting bracket with hook
(Not included).
• Secure the mounting bracket with screws and
wall anchors provided.
• Feed the electrical wires from the ceiling through
opening of the mounting bracket.
B) Assemble the appliance with the hook.
• You can extend the power cord by twisting the cap
cover (4) if the internal wires of power cord (1) are
too short for connection.
• Please make sure the wires are connected to the
corresponding wires terminal of the power circuit
system. The wires of the power cord are coloured
as below:
a) Blue = Neutral (N)
b) Brown = Live (L)
c) Green and yellow = Earth (E)
• Wrap the connected wires together with the elec-
trical insulation tape or wiring nuts (Both are not
included).
• Hang the hole (1) of the aplliance with the hook
as provided on the mounting bracket. (Not sup-
plied).
Important: Please make sure the appliance is se-
cure and correctly connected after installation.
Operation
Attention: Make sure the electrical power system
circuit of ceiling is CLOSED and switch OFF the
hanging lamp at the “0” position.
• First, screw in clockwise direction the shatter-
proof lamp (supplied) securely inside the lamp
holder.
• This appliance has a retractable power cord to
about 150 cm that allows the lamp height to be
adjusted. Rotate the knob (3) to set the length of
the power cord as desired.
• Then, pull gently straight down on the shade
to extend the cord until the desired height is
reached.
• Next, open the electrical power system circuit
and switch ON the appliance by pressing the
switch (5) to the “I” position.
• Now, the lamp is light up and keep food warm
process is started.
•
CAUTION! HOT SURFACE! The lamp shade
(6) surface is very hot during use. Do not
touch it. Switch OFF the lamp & cool down
before setting the cord length.
Important: Remember to keep at least 0,3m dis-
tance from the lighted bulb.
Cleaning and Maintenance
Attention: Shut OFF the electrical power circuit
system, switch OFF the hanging lamp to the “0”
position and let it cool down completely before
cleaning & storage.
Cleaning
• Clean the appliance before first use and regularly.
• Never immerse the appliance in water or other
liquids.
• Do not clean the appliance with a water jet or di-
rect washing under water.
• Clean the surface with a slightly damp cloth or
sponge with some mild soap solution
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Make sure the hanging lamp has been cleaned
and dried before further use.
Storage
• Before storage, always make sure the appliance
has already been disconnected and cooled down
completely.
• Store the appliance in a cool, clean and dry place.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 273876 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 273876 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info