742602
11
Zoom out
Zoom in
Previous page
1/144
Next page
11
EN
Troubleshooting
PROBLEM : AND THIS CONDITION EXISTS: THEN DO THIS:
Pilot won’t light
Cylinder valve is closed Open valve
Blockage in orifice or pilot tube Clean or replace orifice or pilot tube.
Air in the gas line
Open gas line and bleed it (pressing control
knob in) for not more than 1-2 minutes or
until you smell gas.
Low gas pressure
Replace propane gas (disposable) cylinder
with a new cylinder
Igniter fails
Use match to light pilot (with match holder,
see picture**); obtain new igniter and
replace
Pilot won’t stay lit
Dirt build up around pilot Clean dir t from around pilot
Connection between gas valve and
pilot assembly is loose
Tighten connection and perform leak test
Thermocouple is not operating
correctly
Replace thermocouple
Burner won’t light
Gas pressure is low
Replace propane gas (disposable) cylinder
with a new cylinder
Blockage in orifice Clear blockage
Control knob is not in "ON” position Turn control knob to "ON" position
Burner flame is low
Note: Do not operate heater
below 5°C (40°F)
Gas pressure is low
Replace propane gas (disposable) cylinder
with a new cylinder
Outdoor temperature is greater than
40˚F and tank is less than 25% full
Replace propane gas (disposable) cylinder
with a new cylinder
Supply hose is bent or kinked
Straighten hose and per for m leak test on
hose
Control knob is fully " ON"
Turn control knob to " OFF", let cool to room
temperature and check burner and orifices
for blockage
Emitter glows uneven
Note: Bottom 1 inch of emitter
normally does not glow
Gas pressure is low
Replace propane gas (disposable) cylinder
with a new cylinder
Base is not on a level surface Place heater on a level surface
Heater is level Clean burner
Carbon build-up Dirt or film on reflector and emitter Clean reflector and emitter
Thick black smoke
Blockage in burner
Turn control knob to "OFF", let cool to room
temperature and remove blockage and
clean burner inside and outside.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 272602 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 272602 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info