Manual Hendi 272404 (page 14 of 178) (English, German, Dutch, French, Italian, Polish)

742604

Zoom out

Zoom in

1/178

Storage

There is no limitation on the storage of the appli-

ance indoors provided that the cylinder is removed

from the appliance.

Between uses:

• Turn control knob OFF.

• Turn gas cylinder OFF.

Store heater upright in an area sheltered from di-

rect contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

If desired, cover to protect exterior surfaces and to

prevent build up in air passages.

Note: Wait until heater is cool before covering.

During periods of extended inactivity or when

transporting:

• Turn control knob OFF.

• Disconnect gas cylinder and move to a secure,

well ventilated location outdoors. DO NOT store

in a location that will exceed 50°C.

Store heater upright in an area sheltered from di-

rect contact with inclement weather (such as rain,

sleet, hail, snow, dust and debris).

If desired, cover heater to protect exterior surfaces

and to prevent build up in air passages.

Note: Wait until heater is cool before covering

Troubleshooting

IF THE PROBLEM IS AND THIS CONDITION EXISTS THEN DO THIS

Pilot won’t light

Cylinder valve is closed Open valve

Blockage in oriﬁce or pilot tube Clean or replace oriﬁce or pilot tube

Air in the gas line

Open gas line and bleed it (pressing control knob in)

for not more than 1-2 minutes or until you smell gas

Low gas pressure

Replace propane gas (disposable) cylinder with a

new cylinder

Igniter fails

Use match to light pilot (with match holder, see

picture**); obtain new igniter and replace

Pilot won’t stay lit

Dirt build up around pilot Clean dirt from around pilot

Connection between gas valve and pilot

assembly is loose

Tighten connection and perform leak test

Thermocouple is not operating

correctly

Replace thermocouple

Burner won’t light

Gas pressure is low

Replace propane gas (disposable) cylinder with a

new cylinder

Blockage in oriﬁce Clear blockage

Control knob is not in "ON" position Turn control knob to "ON" position

Burner ﬂame is low

Note: Do not operate heat

er below 5°C (40°F)

Gas pressure is low Replace gas cylinder

Outdoor temperature is greater than 5°C

(40°F) and tank is less than 25% full

Replace gas cylinder

Supply hose is bent or kinked Straighten hose and perform leak test on hose

Control knob is fully " ON"

Turn control knob to "OFF", let it cool to room tem

perature and check burner and oriﬁces for blockage

Emitter glows uneven

Note: Bottom 2.5cm of

emitter normally does not

normally glow

Gas pressure is low Replace gas cylinder

Base is not on a level surface Place heater on a level surface

Heater not level Level heater

Carbon build-up Dirt or ﬁlm on reﬂector and emitter Clean reﬂector and emitter

Thick black smoke Blockage in burner

Turn control knob to "OFF", let it cool to room temper

ature and remove blockage and clean burner inside

and outside.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 272404 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 2,91 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hendi 272404 Manual

Product: