742338

Hendi 233870 Manual

9
Zoom out
Zoom in
Previous page
1/96
Next page
9
EN
Troubleshooting
If the appliance does not function properly, please check the below table for the solution.
If you are unable to solve the problem, please contact the supplier / service provider.
Problem Possible cause Possible solution
The appliance is too noisy. - Appliance is not supported properly. - Check if the appliance stands
stable (all four feet should be on
the floor firmly).
- The appliance does not
cool sufficiently.
- Freezing time too long.
- The compressor starts
too often.
- Before switching on, the appliance
has not stand still long enough (3
hours) to level off the refrigerant
- Let stand still again before start
to oper the appliance.
- The lid does not close tight. - Contact the supplier
- The seal is not placed tight enough. - Contact the supplier
- Excessive ice formation on the inte-
rior walls of the appliance.
- Time to perform defrost.
See = = > Cleaning and mainte-
nance
- The appliance is located near the
heat source (e.g. stove, heater, etc).
- Keep the appliance away from
the heat source.
- Put too warm or too much food in-
side cabinet of the appliance.
- Cool down the warm food before
put inside the cabinet.
- Do not put too much food inside.
Exterior (7) surface is too
wet.
- Humidity of the outside environment
is too high.
- Put inside a air-conditined room
to lower the humidity.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 233870 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 233870 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info