742360

Hendi 233153 Manual

11
Zoom out
Zoom in
Previous page
1/122
Next page
11
EN
7.3. FIRST USE
Before starting use of a new appliance , it should
be opened and aired. Then, its interior should be
cleaned with warm water.
After connecting to the mains, press the power but-
ton on the control panel (green signal light will be
lighted). The appliance will start. A microcomputer
controller installed in the control panel may ad-
just temperature ranges automatically. The smart
digital controller operates in the following way:
when the temperature increases and a set point
is reached, a compressor is switched on, then it is
switched off, when the temperature reaches a set
value again.
7.4. OPERATION
Before placing the food product in the appliance
chamber, wait until it reaches the requested tem-
perature. All food products placed inside the appli-
ance should be pre-cooled to the internal operating
temperature of the chamber. Do not place inside
the appliance any hot food just taken out of oven
or stove. Before placing the food in the appliance,
check whether the actual temperature inside the
chamber corresponds to the the required temper-
ature. The temperature of deep frozen products
should not exceed -18°C. Placing in the appliance
any products that had not been cooled down before
may result in their spoiling or disturb the operation
of the appliance.
To ensure proper operation of the appliance, the
products have to be placed in a way that does not
block the circulation of cooled air inside the appli-
ance. When the door is open, cool air escapes from
the chamber, therefore it is recommended to limit
the door opening frequency to the necessary min-
imum. Ensure the door is open only for a period
necessary to take out or put the food inside. Do not
place any products on the top of the appliance.
7.5. CONTROL PANEL
LIGHTS BUTTONS
Compresor
Up
Illuminated – Compressor on
Blinks – Time delay between two starts enabled (AC
parameter)
Press and release - scrolling functions; increasing the
value of the selected parameter;
In the programming mode, the up button makes it
possible to display parameters’ codes.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 233153 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 233153 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 2,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info