741893
10
Zoom out
Zoom in
Previous page
1/48
Next page
10
EN
EQUIPOTENTIAL CONNECTION
This connection shall be carried between the different
appliances with the terminal marked by the symbol: (see
image).
This terminal enables the connection of Yellow/Green ca-
ble with a section between 2.5 and 10mm² .
The appliance shall be included in an equipotential sys-
tem whose efficiency shall be duly verified according to
the provisions of the laws in force.
6. WATER CONNECTION
Make sure the device is placed near a water connection.
Before connecting the device,
allow enough water through to remove any remnants in
the piping so that they did not get into the magnetic valves.
It is necessary to install a shut-off valve and mechanical
filter between the plumbing and the device. On the back of
the device, in the area marked with a label, the convection
oven has an input G 3/4’’ with a filter.
The inflowing water shall have a pressure value com-
prised between 150 (1,5 bar) and 200 kPa (2bar) and a
maximum temperature of 30°C. If the inflow pressure
value exceeds 200kPa (2bar), a pressure reducer will have
to be installed, calibrated at 200kPa
(2 bar).
WATER TREATMENT
In order to ensure trouble-free operation of the device, the water should have a hardness of maximum 5°dH to
prevent lime deposits. For higher values a water softening station should be installed first.
7. FUMES DISCHARGE
Hot fumes and odours are emitted from the cooking chamber during cooking. This is located at the top part
of the back of the oven. Do not place objects on the discharge so as not to hinder the outflow of the fumes
and hence avoid causing damage thereto. It is advisable to position the oven under a suctioning or ensure
adequate ventilation to outside for hot fumes and odours through a pipe no smaller than the oven drainage.
Avoid bends and blockages.
8. STACKING OVENS
Stacking several ovens requires the use of the special kit which keeps the correct distance between the two
ovens.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 223376 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 223376 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 2,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info