577502
9
Zoom out
Zoom in
Previous page
1/28
Next page
9
5.3 With the battery in a fully discharged
state, a high charging current will be
indicated on the ammeter. As the battery
is charged, the charging current will get
smaller until finally only a slight current
flows which maintains the charge. The
charging current is regulated
automatically which means that the
battery cannot be overcharged.
5.4 The state of charge of the battery can
be obtained by measuring the electrolyte
density with a hydrometer.
Warning: The battery acid is extremely
caustic.
Electrolyte density values:
1.28—battery fully charged
1.21—battery half charged
1.14—battery discharged
5.5 If the charging current does not get
smaller as it should, the battery is
defective, e.g. short-circuit between cells,
battery is very old.
6.0 Special instructions
6.1 The protection switch protects the unit
in the event of overload, shortcircuited
terminals or incorrect polarity. The
protection switch should trip at a charging
current of 8 A, to protect the rectifier, the
electronic charging control and the
transformer from being damaged. The
actuation time for the protection switch
may vary depending on the overload.
6.2 If an extremely discharged battery
also causes the protection switch to trip
in the 8 A stage, switch the protection
switch back on.
If the protection switch trips repeatedly;
do not repeat charging operation. The
cause may be a defective battery.
6.3 When the charger is connected a
reverse current of approx. 0.12 A is
drained from the battery in the event of a
power failure, when the power switch is
switched off or when the protective switch
trips. This value
increases to approx. 0.5 A when the work
lamp is switched on. The battery can be
discharged by this reverse current.
To prevent this, the charger should be
disconnected from the battery.
Automatic electronic charger for
continuous use in safety.
The electronics switch the charging
process off when the cell voltage at the
start of gassing is reached.
6.4 Change fuse (230 V - 15 A) as shown
in the illustration.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hella 10 Automatic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hella 10 Automatic in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info