665944
2
Zoom out
Zoom in
Previous page
1/12
Next page
SLOGBD
HR
Sender Batterieinstallation
Der Sender wird durch eine 3 Volt
Lithium CR2032 Batterie betrieben,
welche im Lieferumfang enthalten
und bereits eingelegt ist.
Entfernen Sie lediglich die
Schutzfolie, welche seitlich aus dem
Sender herausschaut, so dass ein
elektrischer Kontakt hergestellt wird.
Um die Batterie zu wechseln,
entfernen Sie zunächst das
Namensschild auf der Vorderseite
des Senders und lösen die
Schraube. Entfernen Sie dann die
Rückseite des Senders durch
vorsichtiges Eindrücken des
Riegels mit einem kleinen,
schmalen Schraubendreher.
Tauschen Sie die alte Batterie aus.
Überprüfen Sie, ob die Batterie
gemäß der angegebenen Polarität
(+ = oben) richtig eingelegt ist.
Setzen Sie die Rück- und Vorder-
seite des Senders wieder
zusammen. Der Sender ist nun
betriebsbereit.
Empfänger Steckdosenanschluss
Der Funkempfänger wird zur
Stromversorgung an die Steckdose
angeschlossen und benötigt keine
Batterien.
Sender Befestigung
Sie können die beiden
vorgestanzten Löcher auf der
Rückseite des Senders als
Schablone verwenden, um die
Bohrlöcher zu markieren.
Instalacija baterije oddajnika
Oddajnik poganja 3 voltna litijeva
baterija CR2032, ki je vsebovana v
obsegu dobave in že vložena.
Odstranite samo zaščitno folijo, ki ob
strani gleda ven iz oddajnika, tako da
se vzpostavi električni kontakt.
Za menjavanje baterije najprej
odstranite ploščico za ime na
sprednji strani oddajnika in odvijte
vijak. Nato odstranite hrbtno stran
oddajnika, tako da zapah previdno
potisnete noter s pomočjo majhnega,
ozkega izvijača.
Staro baterijo zamenjajte.
Prekontrolirajte, ali je baterija v skladu
z navedeno polarizacijo
(+ = zgoraj) pravilno vstavljena.
Hrbtno in sprednjo stran oddajnika
zopet sestavite. Oddajnik je sedaj j
pripravljen za uporabo.
Priključitev sprejemnika na vtičnico
Brezžični sprejemnik se za
napajanje priključi na vtičnico in ne
potrebuje baterij.
Pritrditev oddajnika
Obe predhodno narejeni luknji
na hrbtni strani oddajnika lahko
uporabite kot šablono za
označevanje vrtin. Ustrezni zatiči in
vijaki so vsebovani v obsegu dobave.
Ugradnja baterija u odašiljač
Odašiljač pokreće 3-voltna litijeva
CR2032 baterija koja je
obuhvaćena isporukom i već je
umetnuta. Samo uklonite zaštitnu
foliju koja bočno strši iz odašiljača
kako biste uspostavili električni
kontakt.
Za zamjenu baterije najprije uklonite
pločicu s imenom na prednjoj strani
odašiljača, a potom otpustite vijak.
Potom skinite stražnju stranu
odašiljača oprezno utiskujući zasun
malenim, uskim odvijačem.
Zamijenite staru bateriju. Provjerite
je li baterija pravilno umetnuta u
skladu s navedenim polaritetom (+
= gore). Ponovno sastavite stražnju
i prednju stranu odašiljača.
Odašiljač je sada spreman za rad.
Priključivanje prijemnika na utičnicu
Bežični se prijemnik za napajanje
strujom priključuje na utičnicu i ne
treba baterije.
Pričvršćivanje odašiljača
Obje izrezane rupe na stražnjoj
strani odašiljača možete koristiti kao
šablonu za označavanje rupa za
bušenje. Prikladni moždanici i vijci
priloženi su.
Transmitter Battery Installation
The transmitter is operated by
a 3 Volt Lithium CR2032 battery,
which is included in delivery
and is pre-installed inside the
transmitter. Just remove the
protective foil sticking out from the
side of transmitter, which will
establish the electrical contact.
To change the batteries, first
remove the nameplate on the front
of the transmitter and unscrew the
screw. Then remove the back of
the transmitter by carefully pushing
in the latch with a small, thin
screwdriver.
Replace the old battery.
Please check if the battery is
inserted correctly according to the
polarity (+ = up). Reassemble the
back and front of the transmitter.
The transmitter is now ready for
operation.
Receiver Wall Socket Connection
The wireless receiver can be
connected to a wall socket for
electricity supply and does not
need any batteries.
Mounting the Transmitter
The pre-cut holes on the back of
transmitter can be used as a
template to mark the drilling holes.
The respective wall-plugs and
screws are included in delivery.
2
1
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70841 - HX Moonlight at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70841 - HX Moonlight in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70841 - HX Moonlight

Heidemann 70841 - HX Moonlight User Manual - German, Dutch, French, Italian - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info