665981
3
Zoom out
Zoom in
Previous page
1/10
Next page
Bell+FlashFlashBell
Code Setting
Switch
Kodierschalter
SLOGBD
HR
Lautstärkeregelung
Die Lautstärke der Melodie kann
wahlweise mit einem Regler auf
laut oder leise gestellt werden.
Öffnen Sie das Batteriefach auf
der Rückseite des Empfängers.
Der Regler befindet sich mittig
über den Batterien und ist mit
HI = laut und LO = leise
gekennzeichnet.
Anwendung des Blitzlichtes
Öffnen Sie das Batteriefach auf
der Rückseite des Empfängers.
Rechts über den Batterien
befindet sich ein Schalter der
mit den Bezeichnungen:
Chime, Light, Chime + Light
gekennzeichnet ist.
Optionen:
1. Option (Chime)
Das Blitzlicht ist ausgeschaltet
und wird beim Betätigen des
Senders nicht aktiviert.
Es ertönt lediglich der eingestellte
Rufton!
2. Option (Light)
Das Blitzlicht ist eingeschaltet
und wird beim Betätigen des
Senders aktiviert.
Der Rufton ertönt bei dieser
Einstellung nicht!
3. Option (Chime+Light)
Das Blitzlicht ist eingeschaltet
und wird beim Betätigen des
Senders aktiviert.
Zusätzlich ertönt der eingestellte
Rufton!
Volume Control
The volume of the melody can be
adjusted optionally to low or high
with a controller. Open the
battery compartment on the back
of the receiver. The controller is
situated in the centre above the
batteries and is marked with
HI (high) and LO (low).
Use of Flashlight
Open the battery compartment on
the back of the receiver. On the
top right above the batteries is a
switch, which is marked: Chime,
Light, Chime + Light.
Options:
1. Option (Chime)
The flashlight is switched off and
will not be activated when
pressing the transmitter.
Only the pre-set call signal will
sound!
2. Option (Light)
The flashlight is switched on and
will be activated when pressing
the transmitter.
The call signal will NOT sound
with this setting!
3. Option (Chime + Light)
The flashlight is switched on and
will be activated when pressing
the transmitter.
In addition the pre-set call signal
will sound!
Reguliranje glasnosti
Glasnost melodije se lahko z
regulatorjem po izbiri nastavi na
glasno ali tiho. Odprite predalček
za baterije na hrbtni strani
sprejemnika. Regulator se nahaja
na sredini nad baterijami in je
označen s HI = glasno in z LO =
tiho.
Uporaba bliskovke
Odprite predalček za baterije na
hrbtni strani sprejemnika. Desno
nad baterijami se nahaja stikalo z
oznakami: Chime, Light, Chime +
Light.
Opcije:
1. opcija (Chime)
Blisk je izklopljen in se pri
sproženju oddajnika ne aktivira.
Zadoni le nastavljeno zvonjenje!
2. opcija (Light)
Blisk je vklopljen in se pri
sproženju oddajnika aktivira.
Zvonjenje pri te nastavitvi
ne zadoni!
3. opcija (Chime+Light)
Blisk je vklopljen in se pri
sproženju oddajnika aktivira.
Dodatno zadoni nastavljeno
zvonjenje!
Regulacija glasnoće
Glasnoća melodije može se po
izboru regulatorom namjestiti na
glasno ili tiho. Otvorite pretinac
za bateriju na stražnjoj strani
prijemnika. Regulator se nalazi u
sredini iznad baterija i označen
je s HI = glasno i s LO = tiho.
Primjena bljeskalice
Otvorite pretinac za bateriju na
stražnjoj strani prijemnika.
Desno iznad baterija nalazi se
sklopka koja je označena
natpisima Chime, Light, Chime +
Light.
Opcije:
1. opcija (Chime)
Bljeskalica je isključena i prilikom
aktiviranja odašiljača ne aktivira
se.
Samo se čuje namješteni pozivni
ton!
2. opcija (Light)
Bljeskalica je uključena i aktivira
se prilikom aktiviranja odašiljača.
Pozivni se ton kod te postavke ne
čuje!
3. opcija (Chime+Light)
Bljeskalica je uključena i aktivira
se prilikom aktiviranja odašiljača.
Dodatno se čuje namješteni
pozivni ton!
Empfänger Batterieinstallation
Schieben Sie die Batteriefach-
abdeckung auf der Rückseite
nach unten und legen Sie die
Batterien ein (nicht im Liefer-
umfang enthalten) 2 x 1,5 Volt
LR14 / Baby.
Beim Einlegen bitte auf Polarität
achten!
Schieben Sie die Batteriefach-
abdeckung des Empfängers
wieder ein. Der Empfänger ist
nun betriebsbereit.
Empfänger Befestigung
Der Empfänger hat auf der
Rückseite ein Befestigungsloch.
Dadurch kann das Gerät an
einer Schraube aufgehangen oder
jederzeit beliebig in einen anderen
Raum mitgenommen werden.
Das Befestigungsmaterial
(Dübel und Schraube) ist im
Lieferumfang enthalten.
Achten Sie bei der Montage
darauf, daß zwischen Wand und
Empfänger ein Abstand von ca.
3mm gelassen wird, damit das
Gerät locker eingehangen
werden kann.
Receiver Battery Installation
Push down the battery cover on
back and insert batteries (not
included in delivery) 2 x 1,5 Volt
LR14 / Baby.
Please mind the polarity!
Push the battery cover of
the receiver back into position.
The receiver is now ready for
operation.
Receiver Mounting
The receiver has an integrated
mounting hole on its rear side.
With that the device can be
mounted on a screw or it can be
taken to another room at any
time.
The fastening materials (screw
and wall-plug) are included in
deliver
y.
When mounting the device,
please maintain the distance of
3mm between wall and receiver
so the device can be hung-up
easily.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70385 - HX Flash at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70385 - HX Flash in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70385 - HX Flash

Heidemann 70385 - HX Flash User Manual - German, Dutch, French, Italian - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info