665926
4
Zoom out
Zoom in
Previous page
1/8
Next page
SLOGBD
HR
Weitere Sender anlernen
Bestücken Sie zunächst den zweiten
Sender mit Batterien (siehe Rubrik
Sender Batterieinstallation), achten
Sie dabei darauf, dass die Batterien
richtig eingelegt sind bzw., dass der
eventuell vorhandene Batterie-
schutzstreifen entfernt ist.
Halten Sie den Druckschalter auf
der Rückseite (siehe Skizze links) für
1 bis 2 Sekunden gedrückt, bis Sie
einen kurzen Piepton hören. Dann
betätigen Sie den Funksender, dieser
stellt nun automatisch eine Frequenz
ein und übermittelt diese an den
Empfänger, welcher daraufhin ertönt.
Hinweis:
Wenn Sie den Druckschalter
betätigt haben und der kurze Piepton
ertönt, müssen Sie innerhalb von
5 Sekunden den Sender auslösen.
Nach 5 Sekunden ertönt für
1 Sekunde ein Dauerton, danach
kann kein Sender mehr angelernt
werden. Wiederholen Sie in
diesem Fall die Prozedur.
Dodjela dodatnih odašiljača
Najprije umetnite baterije u drugi
odašiljač (vidi stavku Postavljanje
baterije u odašiljač) pritom obrativši
pozornost na pravilan položaj baterija
te provjerite jesu li uklonjene zaštitne
trake za baterije, ako postoje.
Pritisno stikalo na hrbtni strani (glejte
skico levo) držite pritisnjeno za 1 do 2
sekundi, da zaslišite kratek pisk.
Nakon toga aktivirajte radioodašiljač.
On zatim automatski postavlja
frekvenciju i šalje je prijamniku koji se
nakon toga oglašava.
Napomena:
Ako ste aktivirali tlačnu sklopku i
oglasio se kratki zvučni signal,
odašiljač morate aktivirati u roku od 5
sekundi.
Nakon 5 sekundi se 1 sekundu
oglašava kontinuirani ton, nakon čega
se više ne može dodijeliti nijedan
odašiljač. U tom slučaju ponovite
postupak.
Training more transmitters
First of all, put batteries into the
second transmitter (see Transmitter
Battery Installation section). Ensure
that the batteries are inserted
correctly and that the battery
protective strips, if there are any, are
removed.
Hold down the pressure switch on
the back (see diagram on the left) for
1 to 2 seconds until you hear a short
beep. Now activate the wireless
transmitter; this sets a frequency
automatically and communicates this
to the receiver, which then beeps.
Note:
If you have pressed the pressure
switch and the short beep sounds,
you must trigger the transmitter
within 5 seconds.
After 5 seconds, a long beep
sounds for 1 second, after which
a transmitter cannot be trained to
the receiver. In such cases, repeat
the procedure.
Priučevanje dodatnih oddajnikov
Najprej drugi oddajnik opremite z
baterijami (glejte rubriko Instalacija
baterije oddajnika), pri tem bodite
pozorni na to, da so baterije pravilno
vstavljene oz. da je eventualno
prisoten zaščitni trak baterije
odstranjen.
Tlačnu sklopku na poleđini
(pogledajte skicu lijevo) držite
pritisnutu 1 2 sekunde, dok ne
začujete kratki zvučni signal. Nato
aktivirajte brezžični oddajnik, ki zdaj
avtomatsko nastavi frekvenco in jo
posreduje sprejemniku, ki se na to
oglasi.
Opozorilo:
Ko ste pritisnili pritisno stikalo in se
zasliši kratek pisk, morate roku 5
sekund sprožiti oddajnik.
Po 5 sekundah se za 1 sekundo
zasliši neprekinjen zvok, po tem se ne
da več priučiti nobenega oddajnika. V
tem primeru postopek ponovite.
Code Setting Switch
Kodierschalter
Kodierschalter /
Code Setting Switch
Empfänger (Beispiel)
Receiver (sample)
3
4
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70369 - HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70369 - HX in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70369 - HX

Heidemann 70369 - HX User Manual - German, Dutch, French, Italian - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info