665970
2
Zoom out
Zoom in
Previous page
1/8
Next page
SLOGBD
HR
Sender Batterieinstallation
Der Sender wird durch eine 3 Volt
Lithium CR2032 Batterie betrieben,
welche im Lieferumfang enthalten
und bereits eingelegt ist.
Entfernen Sie lediglich die
Schutzfolie, welche seitlich aus dem
Sender herausschaut, so daß ein
elektrischer Kontakt hergestellt wird.
Um die Batterie zu wechseln,
entfernen Sie zunächst die
Rückseite des Senders durch
vorsichtiges Eindrücken des
Riegels mit einem kleinen,
schmalen Schraubendreher.
Tauschen Sie die alte Batterie
aus.
Überprüfen Sie, daß die Batterie
gemäß der angegebenen Polarität
(+ = oben) richtig eingelegt ist.
Setzen Sie die Rück- und
Vorderseite des Senders wieder
zusammen. Der Sender ist nun
betriebsbereit.
Empfänger Batterieinstallation
Schieben Sie die
Batteriefachabdeckungen auf der
Rückseite nach unten und legen
Sie die Batterien ein (nicht im
Lieferumfang enthalten 2 x 1,5 Volt
LR6 / Mignon bzw. 2 x 1,5 Volt
LR14 / Baby). Beim Einlegen bitte
auf Polarität achten! Schieben Sie
die Batteriefachabdeckungen der
Empfänger wieder ein. Die
Empfänger sind nun betriebsbereit.
Transmitter Battery Installation
The transmitter is operated by a
3 Volt Lithium CR2032 battery,
which is included in delivery and is
pre-installed inside the transmitter.
Just remove the protective foil
sticking out from the side of
transmitter, which will establish the
electrical contact.
To replace the battery first remove
the back of transmitter by carefully
pressing the latch with a small,
narrow screwdriver.
Replace the old battery.
Please check if the battery is
inserted correctly according to the
polarity (+ = up).
Reassemble the back and front of
the transmitter. The transmitter is
now ready for operation.
Receiver Battery Installation
Push down the battery covers on
back and insert batteries (not
included in delivery) 2 x 1,5 Volt
LR6 / Mignon and 2 x 1,5 Volt
LR14 / Baby respectively).
Please mind the polarity!
Push the battery covers of the
receivers back into position. The
receivers are now ready for
operation.
Instalacija baterije oddajnika
Oddajnik poganja 3 voltna
litijeva baterija CR2032, ki je
vsebovana v obsegu dobave in
že vložena.
Odstranite samo zaščitno folijo,
ki ob strani gleda ven iz
oddajnika, tako da se vzpostavi
električni kontakt.
Za menjavanje baterije najprej
odstranite hrbtno stran
oddajnika, tako da zapah s
pomočjo ozkega izvijača
previdno vtisnete. Staro baterijo
zamenjajte.
Prekontrolirajte, ali je baterija v
skladu z navedeno polarizacijo
(+ = zgoraj) pravilno vstavljena.
Hrbtno in sprednjo stran
oddajnika zopet sestavite.
Oddajnik je sedaj pripravljen za
uporabo.
Instalacija baterije sprejemnika
Pokrov predalčka za bateriji na
hrbtni strani potisnite navzdol in
vložite bateriji (nista vsebovani v
obsegu dobave 2 x 1,5 voltna LR6 /
Mignon oz. voltna LR14 / Baby). Pri
vlaganju pazite na polarizacijo!
Pokrov predalčka za bateriji
sprejemnika zopet potisnite noter.
Sprejemnik je sedaj pripravljen za
uporabo.
Ugradnja baterija u odašiljač
Odašiljač pokreće 3-voltna
litijeva CR2032 baterija koja je
obuhvaćena isporukom i već je
umetnuta.
Samo uklonite zaštitnu foliju koja
bočno strši iz odašiljača kako
biste uspostavili električni
kontakt.
Kako biste zamijenili bateriju,
najprije opreznim utiskivanjem
utora malim, uskim odvijačem
uklonite stražnju stranu
odašiljača. Zamijenite staru
bateriju.
Provjerite je li baterija pravilno
umetnuta u skladu s navedenim
polaritetom (+ = gore).
Ponovno sastavite stražnju i
prednju stranu odašiljača.
Odašiljač je sada spreman za
rad.
Ugradnja baterija u prijemnik
Potisnite pokrov pretinca za baterije
na stražnjoj strani nadolje i umetnite
baterije (2 x 1,5 V LR6/Mignon odn.
2 x 1,5 V LR14/Baby; nisu
obuhvaćene isporukom). Pri
umetanju pazite na polaritet!
Ponovno utisnite pokrove pretinca
za baterije na prijemnicima.
Prijemnici su sada spremni za rad.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70290 - HX Silverline at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70290 - HX Silverline in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70290 - HX Silverline

Heidemann 70290 - HX Silverline User Manual - German, Dutch, French, Italian - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info