801911
39
Zoom out
Zoom in
Previous page
1/177
Next page
15 / 20 AquaRite Pro Rev. C
Electrolytic Cell: Install using the unions provided. Tighten unions BY HAND for a watertight


spillover but preventing overchlorination when operating the spa only.
Wiring

Local electrical codes. To provide safe operation, the AquaRite Pro must be properly grounded.
All metal equipments of the pool must be at the same electrical potential (ground).
Input Power:
Wire the AquaRite Pro to the 230 V
from the subpanel.
This circuit must be protected by a differential protection device that protects against
no more than 30ma leakage current.
Input power to the AquaRite Pro must be 230 V
. Refer to the wiring label on the AquaRite
Pro as well as the diagram below for correct wiring connections.
Drill a 17mm hole
into the return pipe
FLOW
FLOW


Position the saddle clamp's
rubber seal over hole.
Tighten clamp evenly.
TYPICAL 230 V
WIRING
230 V
FROM SUBPANEL
AquaRite
PRO
N
PCB
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hayward Aqua Rite Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hayward Aqua Rite Pro in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info