767753
7
Zoom out
Zoom in
Previous page
1/32
Next page
7
GB
INSTRUCTION OF USE
1. ERECTING (󻉓g 1).
Release transportation-lock.
2. UNFOLDING (󻉓g. 2a, 2b)
Tip forward to open the stroller, and press down folding bars at the back of the stroller until they are
securely engaged.
3. FRONT WHEEL ASSEMBLY
Push both front wheels into position (󻉓g. 3a). Make sure they are locked in place and cannot be
pull o󻉒. When changing the wheel, lie the stroller down in fully assembled state. Press the push
pin (3b) on the wheel frame and pull the wheel o󻉒 (3c).
4. FRONT WHEEL ADJUSTMENT (󻉓g 4)
Slide the front wheel lever up to lock the swivel movement. To release the swivel movement, slide
the lever down.
5. TWIN BRAKE FOR REAR WHEELS (󻉓g. 5)
Press the left & right brake levers down to stop the rear wheels and push the stroller to check.
Attention: Always apply both brakes when parking the stroller.
6. ADJUSTING THE BACK REST (󻉓g. 6a, 6b)
To release the seat to recline back position, open the snap buttons on the 2 rear sides and open
the side zipper completely. To return the seat to sitting position, close the zipper and 󻉓x the snap
buttons again.
7. CANOPY (󻉓g 7)
To use the canopy, 󻉔ip the canopy forward and secure by the Velcro on 2 sides. If don’t want to
use the canopy, simply 󻉔ip the canopy backwards.
8. FOLDING AWAY (󻉓g. 8)
Return the backrest to the sitting position, and 󻉔ip the canopy backwards
a. release the bottom folding bar with your foot;
b. pull up the 2nd safety lock by your hand and push the handle forward to close the stroller;
Secure the stroller with the transport lock
9. SECURE THE CHILD IN THE SEAT BY 5-POINT SAFETY BELT (󻉓g. 9):
Place the child in the seat and push the clips on the waist belt into the buckle on the crotch belt
(the one that comes between the child’s legs). Adjust the length of the belt to your child’s needs.
Always ensure the straps are not twisted or caught on the stroller frame. Check the adjustment
every time you place the child in the seat. To release the harness, squeeze & open the buckle.
Harness adjustment: Insert both fasteners (B) into the buckle (A), ensure that both buttons click
into position. Ensure both shoulder straps (C) are attached to the fasteners (B). Each strap has
its own length adjuster (D). To undo the harness, press the buttons and pull apart. “D” Rings are
provided for 󻉓tment of a full safety harness. The attachment points (D-rings) are located on side
straps.
WARNING: (A child’s safety is your responsibility.) The child should be harnessed in at all times
and should never be left unattended. The child should be clear of moving parts while making
adjustments. This stroller requires regular maintenance by the user.
Attention: Avoid serious injury from failing and sliding out, always use
UPKEEP AND MAINTENANCE
In General
Please check the pushchair functions on a regular basis. Make sure that the frame is stable, the screws
are tight, the latching devices are safely locked, the wheels are securely attached and the brakes are in
working order. Check the cover occasionally, making sure that the stitching is still 󻉓rm, and inspect the
quality of the plastic parts. Any broken or worn working parts should be replaced immediately. Proceed
in the same manner with components that are broken, torn, defect or worn-out. Please use only original
hauck replacement parts.
Do not subject your pushchair to excessive sunshine. This can lead to a fading of textile covers and
plastic parts.
Cleaning the covers
Remove the covers from the frame by loosening the loops, press studs or screws. Please read the
instructions on the sewn-in label before cleaning.
To clean the cover gently, wipe it down evenly using only a damp cloth. As long as there are no plastic,
wood or metal parts on or in the cover, it can be machine-washed at 86°F (30°C) and medium speed.
The cover should be air-dried, but not exposed to excessive sunshine. Please do not dry the cover in
the drier, to avoid shrinking. Do not re-󻉓t the covers until they are completely dried.
Cleaning the frame
Dry the pushchair with a soft cloth after cleaning or after use rain or snow. Use only mild soapy water or
lukewarm water to clean the frame of your pushchair. Plastic parts can be cleaned with mild detergent
cleaners.
Wheel maintenance
Clean and service the wheels regularly. Apply corrosion or lubricant spray on the rim when necessary,
to protect against rust and deposits. Please make sure in winter that road salt residue is removed
immediately by using warm water and damp cloth. Remove dirt from the wheels and axles on a regular
basis.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hauck Drive Sun at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hauck Drive Sun in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info