625440
12
Zoom out
Zoom in
Previous page
1/17
Next page
EN DE
12
3.1.2. Connecting the connecting cable to the
heater
It is simplest to connect the heater connecting cable
while the heater is loose.
1. Turn the heater on its side so that the end with
the controls is upwards.
2. Open the fixing screw at the control end about
10–12 mm out of the bottom of the electrical
box and carefully pull the end-piece from the
electrical box.
3. Burst the pre-machined hole on the end-piece,
and push the connecting cable to the cable
clamp and connector batten through this hole.
4. After the connecting cable has been con-
nected, carefully push the end-piece with the
controls into the electrical box. See fig. 8. Prior
to tightening the
fixing screw of
the end-piece,
make sure that
the edge of the
electrical box
is against the
bottom of the
groove on the
end-piece.
3.1.2. Befestigung des Anschlußkabels am Saunaofen
Die Befestigung des Anschlußkabels geschieht am
leichtesten, wenn der Saunaofen nicht fest montiert
ist.
1. Der Saunaofen wird auf die Seite gelegt, so daß
das Ende mit den Steuergeräten nach oben zeigt.
2. Die Befestigungsschraube des Steuergerä-
teseite wird ca. 10–12 mm aus dem Boden
der Elektrobuchse heraus geschraubt und das
Stirnstück wird vorsichtig von der Elektrobuch-
se abgezogen.
3. Für das Anschlußkabel wird das vorgestanzte
Loch im Stirnstück durchstoßen, durch welches
das Anschlußkabel zur Zugentlastungsklemme
und zum Schaltstreifen geführt wird.
4. Wenn das Anschlußkabel befesfigt ist, wird das
Ende mit den Steu-
ergeräten vorsichtig
auf die Elektrobuch-
se geschoben. Sie-
he Abb. 8. Stellen
Sie vor Festziehen
der Schraube am
Stirnstück sicher,
daß der Rand der
Elektrobuchse in
der Nut des Stirn-
stücks liegt.
3.2. Fastening the Heater on a Wall
See figure 9.
1. The installation rack of the heater has been
fastened to the heater. Unscrew the locking
screw of the rack and detach the installation
support from the heater.
2. Fasten the wall-mounting rack on the wall by
using the screws which come with the rack.
NOTE! There must be a support, e.g. a board,
behind the panel, so that the fastening screws
can be screwed into a thicker wooden material
than the panel. If there are no boards behind
the panel, the boards can also be fastened on
the panel.
3. Lift the heater to
the rack on the
wall so that the
fastening hooks
of the lower part
of the rack go
behind the edge
of the heater body
and the upper part
of the heater is
pressed against
the installation
rack.
4. Lock the edge of
the heater onto
the fastening rack
by a screw.
3.2. Befestigung des Saunaofens an der Wand
Siehe Abb. 9.
1. Das Montagegestell des Saunaofens ist am
Saunaofen befestigt. Entfernen Sie die Ver-
riegelungsschraube des Montagegestells und
nehmen das Gestell vom Saunaofen ab.
2. Befestigen Sie das Montagegestell mit den
dazu gelieferten Schrauben an der Wand. ACH-
TUNG! An den Stellen, an denen die Befesti-
gungsschrauben angebracht werden, muss sich
hinter den Paneelen als Stütze z.B. ein Brett
befinden, in dem die Schrauben fest sitzen.
Falls sich hinter den Paneelen keine Bretter
befinden, können diese auch vor den Paneelen
angebracht werden.
3. Heben Sie den Sauna-
ofen so auf das Gestell
an der Wand, daß die
Befestigungshaken unten
am Gestell hinter den
Rand des Saunaofen-
rumpfes kommen und die
Nut im oberen Teil des
Ofens gegen das Monta-
gegestell gedrückt wird.
4. Schrauben Sie den obe-
ren Rand des Saunaofens
am Montagegestell fest.
Figure 8. Connecting the connection cable
Abbildung 8. Befestigung des Anschlußkabels
D
120
250
240min. 335
min. 265
TYP D min. mm
M45/M45E 115
M60/M60E 130
M80/M80E 180
M90E 200
Figure 9. Location of the mounting rack of the heater (all dimensions in millimeters)
Abbildung 9. Platz des Montagegestells des Saunaofens (alle Abmessungen in Millimetern)
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harvia M90E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harvia M90E in the language / languages: English, German as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info