815498
19
Zoom out
Zoom in
Previous page
1/40
Next page
Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2319 8390-044C
6 6 Troubleshooting and Frequently Asked Questions
Status light error messages:
2 Blinks: Indicates an open feed circuit, typically from
pressure switch or hopper switch. Blink status automatically
clears when feed circuit is complete. Does not blink if door/
hopperisopenedwhenstoveiso󰀨.
3 Blinks:IndicatesthattheESP(ExhaustSensingProbe)
has failed, has a broken connection, or has gone out of range
too many times. This requires a manual reset*.
4 Blinks: Can occur only in Room Temp Mode and
indicates Room Sensing Probe failed or not installed. If a
Room Sensing Probe is then installed, the status light will
automatically reset.
NOTE: Unitwillnotstartin"AUTO"withthisstatuserror.
5 Blinks (In Igniter Auto. Mode Only): Indicates that the unit
hasfailedtolightwithinthe36minutestartcycle.Toreset-
TurnModeSelectorto"OFF",thenturntoeithermodeagain.)
6 Blinks : Indicates that the control has calculated poor or
incomplete combustion occurring for more than 25 minutes.
Asixblinkstatusmaybesetifthestoveisallowedtorunout
ofpellets.Toreset,turnmodeselectorto"OFF"thenback
on to the desired mode. If the unit was not out of pellets, see
Troubleshooting section for more details.
* Manual reset-disconnectpowercordforafewseconds
and reconnect. If error still occurs call your Dealer.
A. Error Code Description
B. Frequently Asked Questions
ISSUES SOLUTIONS
1. Metallic noise. 1. Noiseiscausedbymetalexpandingandcontractingasit
heats up and cools down, similar to the sound produced
byafurnaceorheatingduct.Thisnoisedoesnota󰀨ect
the operation or longevity of your appliance.
2. White ash buildup on glass. 2. Thisisnormal.Cleantheglassusinganynon-abrasive
glass cleaner.
3. Glass has buildup of black soot 3. Excessive build-up of ash. See solution #4. The lower
burn settings will produce more ash, the higher burn
settings produce less. The more it burns on low the more
frequent cleaning of the glass is required.
4. Glass has turned dirty. 4. Excessivebuildup of ash.Thelowerburnsettingswill
produce more ash, the higher burn settings produce less.
The more it burns on low the more frequent cleaning of
the glass is required.
5. Firehastallameswithblacktailsandislazy. 5. The feed rate needs to be reduced or the burnpot needs
cleaning. Heat exchanger or exhaust blower needs
cleaning.
6. Smokystart-uporpu󰀨sofsmokefromtheairwash. 6. Either the burnpot is dirty or there is too much fuel at
start-upandnotenoughair.
7. Largeameatstart-up. 7. This is normal. Flame will settle down once the re is
established.
Contact your dealer for additional information regarding operation and troubleshooting. Visit www.harmanstoves.
com to nd dealer.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman P68-C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman P68-C in the language / languages: English as an attachment in your email.

The manual is 8.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman P68-C

Harman P68-C User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info