815497
16
Zoom out
Zoom in
Previous page
1/40
Next page
Harman® • P-Series Owner’s Manual_R16 • 2018 - ___ • 01/2316 8390-044C
Whenever adding fuel, take the opportunity to clean the burn
pot. (Weekly at minimum)
Scrape the top holed surface and sides of the burn pot
down to auger tube Figure 5.1. It is not necessary to
completely remove all material from the burn pot. The
excesswillbepushedoutduringthenextuse.
• With the re out and burn pot cold, use the supplied
allen wrench to remove any build-up that may have
accumulated in the holes of the burn pot grate. Simply
push the allen wrench down through each hole ensuring
itisclearofanybuild-uppayingattentionnottodamage
the igniter element in the process.
Monthly, or after each ton of fuel burned:
• Loosenthe(2)wingthumbscrewsonthelowerfrontangle
of the burn pot. Figure 5.2
• Lifto󰀨theclean-outcovertoopenthebottomclean-out
chamber. Figure 5.3
Clean ash buildup from inside the chamber while cover
iso󰀨.Usethescrapertotaponthetopfrontedgeofthe
burn pot. This will help knock pieces of ash, loosened
by the scraping process, down through the holes. It also
helpsknockscaleo󰀨oftheigniterelement.
Figure 5.3
The igniter is made to be removable for service by insulated
male/female wire connectors. These connections between
thehotleads(thewiresinsidetheburnpot)andthecold
leads(thewiresfromthecontrolboard)arealwayspulled
to the inside rear of the feeder body. (Not coiled inside the
burn pot.)
It is very important that these connections are to the inside
rearofthefeederbody.Also,theextrawireoftheigniterwire
service loop must be pulled out through the rear of the feeder
and tied up so that it will not be damaged by any moving parts.
Note: The hot lead/cold lead connection must always be
pulled to the rear of the feeder body before operation.
E. Burnpot Maintenance
Figure 5.1
Figure 5.2
Wing Thumb Screws
Figure 5.3 - View from below through the ash pan opening.
Igniter hot lead wires
(High temperature)
Burn pot igniter
Use caution when cleaning burn pot clean-out
chamber. Do not damage the high temperature igniter
wires.
WARNING
Disconnect the power to the unit before removing
cover.
DANGER
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman P61-C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman P61-C in the language / languages: English as an attachment in your email.

The manual is 8.89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman P61-C

Harman P61-C User Manual - French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info