122794

Harman Kardon tc 1000 Manual

25
Zoom out
Zoom in
Previous page
1/38
Next page
21
Harman Kardon
Troubleshooting
If you have difficulty with your Take Con-
trol unit, consult the following problem
descriptions for a quick solution. If you
continue to have difficulties, see the
“Technical Support” section within this
manual for further direction.
Setup
I received a message “Code not
learned. TC1000 detected your button
press, but could not learn the IR code,”
and a beep from the speaker.
Cause The remote control for the
device was not aligned correctly
with the Take Control’s IR receiver.
Solutions
l
Try moving the IR transmitter end of
the remote control right, left, closer,
or further away from the TC1000
system controller. Moving the
remote control around may help to
align the remote control IR transmit-
ter with Take Control’s IR receiver.
l
Align your remote control correctly
with your Take Control. See “Add-
ing, Editing, and Removing Devic-
es,” page 9, and “Adding or
Deleting a Device,” page 18.
Cause The button on the remote
control was not held down long
enough to learn the IR code.
Solution Hold down the button that
needs to be learned on the remote
control until you see the message,
“Code learned.”
Cause The Take Control software is
unable to learn the IR code for the
device or button.
Solution Use Take Control’s internal
list of categories and devices.
If the category and the device you
need are not listed, then you cannot
add this device or button.
Cause The batteries are low in either
the TC1000, the remote control you
are trying to learn, or both.
Solution Replace the batteries, as
needed. For the TC1000, see
“Replacing the Batteries,” page 28.
For the remote control, see the doc-
umentation for the remote control.
Cause The system controller is in
direct sunlight or under fluorescent
lighting.
Solution Direct sunlight or fluores-
cent lighting may cause interference
with the IR signal from the system
controller. Use it away from direct
sunlight or fluorescent lighting.
Cause The electronic device may
have IR frequencies that are incom-
patible with Take Control.
Solution Please contact us at the
number in “Technical Support,”
page 29.
Cause There may be other IR-con-
trolled devices in the room, creating
a conflict with the TC1000 IR signal.
Solution Turn off or refrain from
using other IR-controlled devices.
Cause The button on the remote
control being learned does not work
or is set to an alternate-device
mode, such as VCR when you are
trying to learn a TV button.
Solution Before learning the button
on the remote control, verify that it
works properly by pressing the
button and observing a correct
response on the device.
76009mnl2.p65 9/1/98, 2:27 PM21
Black
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon tc 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon tc 1000 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info