502813
7
Zoom out
Zoom in
Previous page
1/16
Next page
Rear Panel Connections
Using the Reference Card supplied with
this manual, use this section as a quick
guide to the connections required to
install the PT2500. For complete instal-
lation and set up instructions, see pages
7-10.
¡ Phono Input: Connect the output
of a turntable or tone arm to these
jacks.
System Ground Terminal: To
reduce hum and noise, connect the
ground lead from your turntable or
tone arm to this terminal.
£ Aux Input: Connect the outputs
of any audio source to these jacks.
¢ CD Input: Connect the outputs of
a CD player or external D/A convert-
er to these jacks.
Tape 1 Input: Connect the
PLAY/OUT jacks of an audio tape
recorder to these jacks.
§ Tape 1 Output: Connect the
RECORD/INPUT jacks of an audio
tape recorder to these jacks.
Tape 2 Input: Connect the
PLAY/OUT jacks of a second audio
tape recorder to these jacks.
Tape 2 Monitor Output: Connect
the RECORD/INPUT jacks of a sec-
ond audio tape recorder to these
jacks.
ª VCR1 A/V Inputs: Connect the
audio and video PLAY/OUT jacks of
a VCR to these jacks.
VCR1 A/V Outputs: Connect the
audio and video record RECORD/IN
jacks of a VCR to these jacks.
VCR2 A/V Inputs: Connect the
audio and video PLAY/OUT jacks of
a second VCR, or another A/V
source such as a satellite receiver to
these jacks.
¤ VDP A/V Inputs: Connect the
audio and video outputs of a laser
disc or DVD player to these jacks.
Video Monitor Outputs:
Connect these jacks to the video
input of a TV or video projector.
Remote Amplifier Trigger:
Using the accessory cable supplied
with the PT2500, connect this jack to
compatible products such as the
PA5800 for automatic turn on/off
operation.
AC Power Cord: Connect this
plug to an unswitched, wall mounted
AC outlet.
Unswitched Accessory AC
Power Outlet: This outlet provides
AC power that may used with any AC
device up to 100 watts. The power
will remain on at this outlet regardless
of whether the PT2500 is on or off.
Switched Accessory AC Power
Outlet: This outlet provides AC
power to connected products only
when the PT2500 is turned on. Note
that the total current draw of the
products may not exceed 100 watts.
° Remote Control Extension
Output: This jack may be connect-
ed to other compatible Harman
Kardon products so that they will
receive infrared commands cap-
tured by the PT2500’s remote sen-
sor.
· Remote Control Extension Input:
If the PT2500’s front panel IR sensor
is blocked due to cabinet doors or
other obstructions, an external IR
sensor may be used. Connect the
output of the sensor to this jack.
a Surround Channel Outputs:
Connect these jacks to the surround
channel inputs of a power amplifier
or digital audio processor with pass
through capability.
b Center Channel Outputs:
Connect the output of one of these
jacks to the center channel input of
a power amplifier or digital audio
processor with pass through capa-
bility.
NOTE: In most applications only one
center channel connection will be
required. The output of both jacks is
identical, and either jack may be
used for system connections.
c Front Channel Outputs:
Connect these jacks to the front
left/right channel inputs of a power
amplifier or digital audio processor
with pass through capability.
d Subwoofer Outputs: Connect
these jacks to the line level input of a
powered subwoofer, or to the inputs
of a subwoofer amplifier.
NOTE: This output is a full range
left/right signal. For proper operation
BOTH jacks must be connected to
the left/right inputs of a powered
subwoofer, or a “Y” cable must be
used to connect the two outputs
together if a single input mono sub-
woofer is used.
WARNING: Since this is a full range
output, the signal must be sent
through a crossover or low pass filter
before being used with a passive
subwoofer or other speaker that
does not contain a built in crossover.
e AM Antenna Input: Connect the
AM loop antenna supplied with the
PT2500 to these terminals. An exter-
nal AM antenna may also be con-
nected here.
f FM Antenna Input: Connect an
FM antenna to these terminals. Note
that a 300 ohm to 75 ohm adapter is
required for connections from twin
lead dipole antennas.
5
PT2500 rev (G) 10/23/96
•PT2500(g).qx 10/23/96 7:36 AM Page 6
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon PT2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon PT2500 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info