534549
3
Zoom out
Zoom in
Previous page
1/8
Next page
2
2 3
ENGLISH
Speaker Placement
Expanding a 5.1-Channel System to a 7.1-Channel System
The surround back speakers should be placed against the rear wall directly behind the
listeners, 3–6 feet (0.9m–1.8m) apart, 5–6 feet (1.5m–1.8m) off the floor.
Surround Back
Right Speaker
3 - 6 ft
(0.9m - 1.8m)
5 - 6 ft
(1.5m - 1.8m)
Surround Back
Left Speaker
Center
Speaker
If original surround speakers are
behind listeners, move them to a point
to directly at listeners' sides
Front Left
Speaker
Surround Left
Speaker
Surround Right
Speaker
Surround Back
Right Speaker
Surround Back
Left Speaker
Front Right
Speaker
Subwoofer
TV
NOTE: If your original surround speakers are located behind the listeners, you should move
them up so they are directly to the listeners sides.
If You’re Adding to an Existing HKTS 30 Speaker System:
Your HKTS30SAT-2 speakers are designed to expand an existing HKTS30 speaker system
from 5.1 channels to 7.1 channels. You can connect the HKTS30SAT-2 speakers to your
receiver’s or amplifier’s surround back left and surround back right outputs.
If You’re Adding to an Existing HKTS 20 Speaker System:
Your HKTS30SAT-2 speakers are designed to expand an existing HKTS20 speaker system
from 5.1 channels to 7.1 channels by replacing the existing front left and front right
speakers. You can then connect your existing HKTS20 front left and front right speakers to
your receiver’s or amplifiers surround back left and surround back right outputs.
Mounting Options for HKTS30SAT-2 Speakers
Shelf Placement
You can place the HKTS30SAT-2 speakers on
shelves. The satellite speakers have built-in bases
for shelf placement. You can also remove the
bases if desired.
To remove a speaker’s base, pull it straight off the
speaker, as shown in the illustration. Applying
even pressure to both sides of the base will allow
it to slide off smoothly.
Wall-Mounting
IMPORTANT: Read the Speaker Connections
section, on page 5, before wall-mounting the
HKTS30SAT-2 speakers. You will need to insert
the speaker wires through the wall mounts and
connect the wires to the speakers during the
process of installing the wall-mounts.
NOTE: If you are using your own speaker wire, it must be no
thicker than the wire supplied with the speakers. Thicker wire will
prevent the wall-mount bracket from sliding onto the speaker.
Decide on the location for the speaker 1.
(see Speaker Placement, opposite).
Remove the speaker’s base as explained in 2. Shelf Placement, above.
Disassemble the wall-mount bracket by sliding the two sections apart, as shown in 3.
the illustration.
Attach the wall portion of the wall-mount onto the wall using hardware that is 4.
appropriate for the wall’s construction and materials. We recommend first anchoring
the mount using its keyhole, then attaching it with another anchor through its top
opening, as shown in the illustration. Note that the HKTS30SAT-2 speakers weigh
3.3 lb (1.5kg). Be sure to use hardware that can support this weight.
Top Opening
Keyhole Opening
Bottom Opening
Apply Pressure Evenly
to Both Sides of Base
Lift Base Straight
off Speaker
Pull Sections
Apart
0209CSK - HK HKTS30SAT-2 Inlay.indb 3 09/04/10 8:56:01
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon HKTS30SAT-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HKTS30SAT-2 in the language / languages: English as an attachment in your email.

The manual is 0,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon HKTS30SAT-2

Harman Kardon HKTS30SAT-2 User Manual - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info