Manual Harman Kardon HK3390 (page 19 of 28) (English)

502537

Zoom out

Zoom in

1/28

INSTALLATION

transmitted through the HK 3390 to the source device. This enables

you to control your sources even when the HK 3390 itself is controlled

via an external IR receiver.

To control more than one source device using the Remote IR Output,

connect all sources in a “daisy chain” fashion, with the HK 3390’s

Remote IR Output connected to the first device’s Remote IR Input, that

device’s Remote IR Output connected to the next device’s Remote

IR Input, and so forth. See Figure 19.

Figure 19 – Remote IR Input and Output

NOTE: Not all remote-controllable devices are equipped with

compatible IR inputs and outputs. Check with the manufacturer of

the source device for more information on the type of IR signal

expected. The HK 3390 will output a “stripped carrier” IR signal.

Step Seven – Connect Optional External

Equipment

If you wish to use the HK 3390 with an external power amplifier,

remove the jumpers connecting the Preamp Outputs and Main-Amp

Inputs. Store the jumpers in a safe place in case they are needed in the

future. Connect the left and right Preamp Outputs of the HK 3390 to the

analog audio inputs on the external power amplifier. See Figure 20.

Figure 20 – Preamp Outputs and Main-Amp Inputs

You may adjust the Volume and Tone Controls using the HK 3390’s

front panel or remote (volume only).

If you wish to install an external processor, such as an equalizer, connect

it to the Preamp Outputs and Main-Amp Inputs. Remove the jumpers

and store them in a safe place. Connect the HK 3390’s Preamp Outputs

to the processor’s analog audio inputs, and then connect the processor’s

analog audio outputs to the Main-Amp Inputs on the HK 3390.

Alternatively, you may connect the external processor to the HK 3390’s

Tape Monitor Loop. See Figure 14.

Step Eight – Plug In AC Power

Having made all of your wiring connections, it is now time to plug each

component’s AC power cord into a working outlet.

You may plug two devices into the AC Switched Accessory Outlets on

the rear of the HK 3390. See Figure 21. Make sure each device draws

no more than 100 watts. The devices should have their mechanical or

master power switches turned on, and they will power on any time the

HK 3390 is turned on.

Figure 21 – Switched AC Accessory Outlets

Step Nine – Insert Batteries in Remote

The HK 3390 remote control uses four AAA batteries, which are included.

To remove the battery cover located on the back of the remote, squeeze

the tab and lift the cover.

Insert the batteries as shown in the diagram, making sure to observe

the correct polarity. See Figure 22.

Figure 22 – Remote Battery Compartment

When using the remote, point the lens toward the front panel of the

HK 3390. Make sure no objects, such as furniture, are blocking the remote’s

path to the receiver. Bright lights, fluorescent lights and plasma video

displays may interfere with the remote’s functioning. The remote has a

range of about 20 feet, depending on the lighting conditions. It may be

used at an angle of up to 30 degrees to either side of the HK 3390.

If the remote seems to operate intermittently, then make sure the batteries

have been inserted correctly, or replace the batteries with fresh ones.

Step Ten – Turn On the HK 3390

Place the HK 3390 in Standby mode by turning on the Main Power Switch

on the rear panel. The Power Indicator will turn amber. The HK 3390 may

be turned on from Standby mode by pressing the Power Switch or any

Source Selector on either the front panel or the remote. See Figures 23

and 24.

Figure 23 – Front-Panel Power Switch

Figure 24 – Remote Control Power Switch

HK 3390

HK1695 3390OM 6/13/08 12:12 PM Page 19

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HK3390 in the language / languages: English as an attachment in your email.

The manual is 2,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon HK3390

Harman Kardon HK3390 User Manual - Dutch - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Harman Kardon HK3390 Manual

Product: