502818
12
Zoom out
Zoom in
Previous page
1/24
Next page
Remote Control Functions
å Main Power On: When the
HK3270 is in the Standby mode, as
indicated by the Power Indicator 3
glowing amber, press this button to
turn the HK3270 on.
Main Power Off: When the
HK3270 is turned on, press this
button to place it in the Standby
mode. Note that in this condition,
the unit is still connect to AC Power.
ç Source Selectors: Press these
buttons to select an input source for
the HK3270.
Preset Up/Down: When the
tuner is in use, these buttons scroll
through the stations that have been
programmed into the HK3270’s
memory. These buttons also control
the track Skip Up and Down on com-
patible Harman Kardon compact
disc players/ changers.
Transport Controls: These but-
tons are used to control Play, Play
Forward, Play Reverse, Stop, Pause
and Record functions on compatible
Harman Kardon compact disc players/
changers and cassette tape decks.
ƒ Disc Skip: These buttons do not
have any functions when controlling
the HK3270, but they operate the
Disc Skip functions of compatible
Harman Kardon compact disc
changers.
© Sleep Button: Press this button
to place the unit in the Sleep mode.
After the time shown in the display,
the HK3270 will automatically go into
the Standby mode. Each press of
the button changes the time until
turn-off in the following order:
90
min
80
min
70
min
60
min
50
min
40
min
30
min
20
min
10
min
OFF
˙ Dimmer: Press this button once
to reduce the brightness of the front
panel display to half the normal
intensity. Press it again to turn the
front panel display completely off.
When the display is completely off,
press the button to return to normal
brightness.
Tuning: Press these buttons to
tune up or down through a selected
frequency band.
Master Volume: Press these
buttons to raise or lower the
HK3270’s volume.
PScan: Press this button to
automatically scan through the list of
stations that are programmed into
the HK3270’s tuner memory. When
the button is pressed, each preset
station will play for five seconds
before the next station is selected.
Press the button again when the
desired station is heard to stop the
preset scan.
¬ Mute: Press this button to
momentarily silence the HK3270.
µ FM Mode: Press this button when
the tuner is in use in the FM band to
switch to monaural reception if the
station is weak and noisy. When the
MONO indicator is on, FM reception
will be monaural regardless of the
strength of the tuned FM station.
(See page15 for more information.)
Tuning Up/Down: When the tuner
is in use, these buttons will tune up or
down through the selected frequency
band. A brief (
1
2 second) press of
the button will manually tune to the
next frequency increment, while
pressing and holding the button for a
longer period will automatically tune
to the next station with a signal strong
enough for acceptable reception.
These buttons will also control Fast
Forward and Fast Reverse
(or Rewind) for compatible Harman
Kardon compact disc players/
changers and cassette tape decks.
O Direct: Press this button to select
a radio station by entering its fre-
quency using the Numeric Keys R.
(See page15 for more information.)
P Numeric Keys: These buttons
serve as a ten-button numeric key-
pad to enter tuner preset positions.
Q Auto Preset: When the tuner and
FM band have been selected, this
button may be used to automatically
program the tuner presets for all
active stations. To start the auto pre-
set scan, press and hold the button.
Note that the MEMO and PRESET indi-
cators will flash. After a few seconds,
the tuner will start to “look” for active
stations, as shown by increasing fre-
quency numbers in the Information
Display. Release the button and note
that the tuner will briefly stop at each
active station and add a preset num-
ber to the memory. If the FM tuner
found less the 30 FM stations with
acceptable signal strength, the Auto
Preset tuning will scan two more
cycles or until the remaining vacant
preset memory spaces have been
filled with those found in the first
scan. The scan will stop when all 30
preset memory spaces have been
filled or when three scans through
the band have been completed.
R Secondary Control Cover: This
sliding cover normally is in the “up”
position so that it hides the sec-
ondary controls. To access these
controls, place your thumb on the
small recessed area at the top cen-
ter of the control, and gently press
the cover down and towards you.
S Clear Button: This button is used
to clear preset memory information
for the HK3270’s tuner. (See pages
1516 for more information on tuner
presets.)
T Memory: Press this button to
open a memory position that stores
a preset location for the HK3270’s
tuner. (See pages1516 for more
information on tuner presets.)
13
HK3270 "U" om (B) 2/5/99 10:40 AM Page 13
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon HK3270 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HK3270 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info