502808
21
Zoom out
Zoom in
Previous page
1/28
Next page
21
Now that you have installed your system components, you are ready
to begin enjoying your new audio system.
Turning On the HK 3385
After you plug the power cord into an AC outlet, the Power Indicator should
light up in amber. This indicates that the HK 3385 is in Standby mode and
is ready to be turned on. See Figure 23.
The HK 3385 may be turned on by pressing the Power Switch on the
front panel or the remote. See Figure 24.
The Power Indicator will turn red briefly, and then blue to indicate that
the HK 3385 is on. If it remains red, then unplug the receiver from
AC power and check all of your wires and connections. Make sure no
speaker wires are shorting out by touching each other, and that there
are no breaks in the insulation covering any of the speaker wires, inter-
connects or the power cord. If the Power Indicator remains red when
you plug in the HK 3385 and try to turn it on again, then bring the
receiver to an authorized Harman Kardon service center for assistance.
To turn the receiver off, press the Power Switch on the front panel,
or press the Power Off Button on the remote. When the HK 3385 is
left unplugged, any settings you have programmed, including system
configuration and preset radio stations, will be preserved indefinitely.
Sleep Timer
You may program the HK 3385 to play for up to 90 minutes and then
turn off automatically using the sleep timer.
Press the Sleep Button on the front panel or remote, and the time until
turn-off will be displayed. Each additional press of the Sleep Button will
reduce the time until turn-off by 10 minutes, until the OFF setting is
reached, which disables the sleep timer. See Figures 25 and 26.
Figure 25 – Front-Panel Sleep Button Figure 26 – Remote Control Sleep Button
When the sleep timer has been set, the front-panel display will automati-
cally dim to half-brightness. If you press any button on the remote or
front panel, the display will return to full-brightness. The display will dim
again several seconds after your last command.
If you press the Sleep Button after the timer has been set, the remaining
time until turn-off will be displayed. You may press the Sleep Button to
change the time until turn-off. Pressing and holding the Sleep Button will
disable the sleep timer, and the SLEEP OFF message will appear.
Volume Control
The volume may be adjusted either by turning the knob on the front
panel (clockwise to increase volume or counterclockwise to decrease
volume), or by pressing the Volume Control Buttons on the remote. See
Figure 27. The volume is displayed as a negative number of decibels
(dB) below the 0dB reference point. Unlike some volume controls on
other products, 0dB is the maximum volume for the HK 3385. Although
it’s physically possible to turn the volume to a higher level, doing so may
damage your hearing and your speakers. For certain more-dynamic
audio materials, even 0dB may be too high, allowing for damage to
equipment.
Figure 27 – Volume Controls
Remember that the HK 3385 is designed to reproduce audio with a
minimum amount of distortion. This clarity may lead you to believe that
your hearing and the equipment can handle higher volumes. We urge
caution with regard to volume levels.
Mute Function
To temporarily mute all speakers and the headphones, press the Mute
Button on the front panel or remote. See Figure 28. Any recording in
progress will not be affected. The MUTE message will flash in the
display as a reminder. To restore normal audio, either press the Mute
Button again, or adjust the volume. Turning off the HK 3385 will also
end muting.
Figure 28 – Mute Buttons
Tone Controls
You may boost or cut either the treble or the bass frequencies by up
to 10dB.
The Bass and Treble Tone Controls may be adjusted by turning the
knobs on the front panel. Turn either knob counterclockwise to reduce
the levels of the low frequencies (Bass Control) or the high frequencies
(Treble Control), and turn either knob clockwise to increase the levels
for the low or high frequencies. See Figure 29.
Figure 29 – Tone Controls
You may also adjust the balance to compensate for speaker placement
or the acoustic characteristics of your listening room. Ideally, the audio
should be heard most clearly at a point exactly midway between the left
and right speakers, unless the artist has mixed the recording in a way
that pans sounds to one side or the other. If your speakers are not
placed the same distance from the listening position, or if your room has
other unusual characteristics, turn the Balance Control knob on the front
panel counterclockwise to move the sound toward the left speaker or
clockwise to move the sound toward the right speaker. See Figure 30.
OPERATION
HK 3385 OM 4/13/07 12:03 PM Page 21
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon HK 3385 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon HK 3385 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info