502655
21
Zoom out
Zoom in
Previous page
1/40
Next page
System Configuration
AVR85 120 rev (g) 6/14/97
18
System Setup
Once the speakers have been placed in
the room and connected, the final step
is to enter the configuration information
and balance the speaker output levels.
Before proceeding further this is a good
time to review the installation section
of the manual to make certain that all
connections are properly made.
1. Plug the unit into an AC wall outlet
and press the Power button on either
the front panel 1 or the remote c.
Note that the ring surrounding the front
panel switch will turn green, and the
front panel display will illuminate.
2. Install the supplied AAA batteries in
the remote as shown on page 15.
3. Turn on the TV connected to the
receiver. Select the appropriate video
input on the TV.
Note: Although the unit will switch
S-Video signals, the on-screen menus
control system is NOT visible on the
S-Video output.
4. Press the Select button j on the
remote to bring the MAIN MENU up on
your video screen.
5. Press the ¤ button four times until
the on-screen cursor
>
is pointing to
SET UP MENU (see figure #1).
6. Press Select j to move to the
next screen, SET UP MENU 1 (see
figure #2).
7. SET UP MENU 1 enters the
information that tells the AVR85 which
type of front and surround speakers
will be used. In turn, these settings will
determine which speakers receive low
frequency (bass) information. For the
purposes of establishing proper bass
reproduction, use the LARGE settings if
the speaker being used at any position
is a traditional full-range loudspeaker
that is capable of reproducing sounds
below 100Hz. Use the SMALL setting for
smaller, frequency-limited satellite
speakers that are not able to reproduce
sounds below 100Hz. Note that when
“small” speakers are used it is advisable
to install a separate subwoofer.
8. Enter the information for the FRONT
CH. speaker by using the or buttons
i on the remote to select the type of
front channel speaker that will be used.
Press the buttons so that LARGE or
SMALL is highlighted to match the
speaker type you will use as described in
item #7 above. The LARGE setting sends a
full-range output to the front left/right
speakers, while the SMALL setting sends
low-frequency sounds to the subwoofer
output. When the selection has been
made, press the ¤ button once so that
the on-screen cursor
>
is pointing
to the SURROUND CH. line of the
display.
INPUT SELECTOR
SURROUND MODE
TEST TONE
MULTI ROOM SEL:OFF
SET UP MENU
SLEEP TIMER:OFF
MENU OFF
MAIN MENU
Figure 1
SPEAKER SETTING
FRONT CH
.
LARGE
SMALL
SURROUND CH
.
LARGE
SMALL
NONE
GO TO SET UP MENU 2
RETURN TO MAIN MENU
SETUP MENU 1
Figure 2
CENTER CH
.
LARGE
SMALL
NONE
SUBWOOFER ON
OFF
GO TO SET UP MENU 3
RETURN TO MAIN MENU
SETUP MENU 2
Figure 3
LFE LEVEL CONTROL
OFF:0dB - 10dB
NIGHT MODE :OFF ON
SETUP LOCK :LOCK
UNLOCK
GO TO SET UP MENU 4
RETURN TO MAIN MENU
SETUP MENU 3
Figure 4
OFF ON
FRONT L
TEST TONE
0 dB
Figure 5
AVR85 om (g) 9/16/98 11:21 AM Page 18
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR85 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info