Operation
Recalling Preset Stations
•To manually select a station previously
entered in the preset memory, press the
Numeric Buttons
37
w
correspond-
ing to the desired station’s location. To
select the station in location “30,” press
the 0 button only.
•To manually tune through the list of
stored preset stations one by one, press
the Preset/Disc Skip buttons
s
on
the remote.
•To automatically scan through the
stations entered in the preset memory,
press the P
.
Scan button
v
on the
remote. The tuner will run through the
list of preset stations, stopping for five
seconds at each one. Press the P
.
Scan
button again to stop the scan at your
desired station.
Tape Recording
In normal operation, the audio or video
source selected for listening through the
AVR55 is sent to the record outputs.
This means that any program you are
watching or listening to may be recorded
simply by placing machines connected
to the outputs for Tape 1 or Tape 2
‚•in the record mode.
When a tape recorder with separate
record and playback heads is used, you
may monitor the output of the recording
by selecting the
Tape 1/Monitor input
!d
. Note that the T
•
MON indicator
K
will illuminate in the front panel dis-
play to remind you that you are listening
to the record playback instead of the
actual input source being recorded.
NOTE: When a Dolby Digital source is
playing, the output may not be recorded.
Video Recording
The AVR55 permits you to make a video
recording from one of the input sources
while another source is being listened to
through the unit’s main amplifiers.
To make a video recording, press the
Video 1 Record button
&
and
observe the indicator dot at the far left
side of the front panel Information
Display
35
. As you press the Record
button, the Video 1 Record indicator
A
will change to show which output is
being sent to the
Video 1 Out jacks
›
.
The output may be either the current
listening source, or one of the other video
inputs (TV, DVD, Video 2).
IMPORTANT NOTE: Please make cer-
tain that you are aware of the copyright
restrictions on any material you copy.
Unauthorized duplication of copyrighted
materials is prohibited by Federal law.
Output Level Trim Adjustment
Normal output level adjustment for the
AVR55 is established using the Test Tone,
as outlined on page 19. In some cases,
however, it may be desirable to adjust the
output levels using program material
such as a test disc, or a selection you are
familiar with.
To adjust the output levels using pro-
gram material, first set the reference
volume for the front left/right channels
using the
Volume Control
˘n
. If
you wish to vary the difference between
the left and right channels, use the
Balance Control Ù.
To change the level for the channels you
wish to adjust use the appropriate front
panel level adjust control for the
Subwoofer, Center or Surround
channels
¸˝
34
.
Memory Backup
This product is equipped with a memory
backup system that preserves tuner pre-
sets and system configuration informa-
tion if the unit is accidentally unplugged
or subject to a power outage. This mem-
ory will last for approximately two weeks,
after which time all information must be
reentered.
29
