502548
50
Zoom out
Zoom in
Previous page
1/58
Next page
Troubleshooting Guide
Processor Reset
In the rare case where the unit’s operation or the
displays seem abnormal, the cause may involve
the erratic operation of the system’s memory or
microprocessor.
To correct this problem, first unplug the unit from
the AC wall outlet and wait at least three
minutes. After the pause, reconnect the AC
power cord and check the unit’s operation. If the
system still malfunctions, a system reset may
clear the problem.
To clear the AVR’s entire system memory
including tuner presets, output level settings,
delay times and speaker configuration data, first
put the unit in Standby by pressing the System
Power Control button
2
. Next press and hold
the OK button
6
for five seconds.
The unit will turn on automatically and show the
word RESET in the Display for a few seconds.
Then it reverts to normal ON status. Note that
once you have cleared the memory in this manner,
it is necessary to re-establish all system
configuration settings and tuner presets.
NOTE: Resetting the processor will erase any
configuration settings you have made for
speakers, output levels, surround modes, digital
input assignments as well as the tuner presets.
After a reset the unit will be returned to the
factory presets, and all settings for these items
must be reentered.
If the system is still operating incorrectly, there
may have been an electronic discharge or severe
AC line interference that has corrupted the
memory or microprocessor.
If these steps do not solve the problem, consult
an authorized Harman Kardon service depot.
SYMPTOM CAUSE SOLUTION
Unit does not function when Main No AC Power Make certain AC power cord is plugged
Power Switch
1
is pushed into a live outlet
Check to see if outlet is switch controlled
Display lights, but no sound Intermittent input connections Make certain that all input and speaker
or picture connections are secure
Mute is on Press Mute button
c
G
Volume control is down Turn up volume control
No sound from any speaker; Amplifier is in protection mode Check speaker-wire connections for shorts at receiver
Protect Warning in Display due to possible short and speaker ends
Amplifier is in protection mode Contact your local Harman Kardon service depot
due to internal problems
No sound from surround or Incorrect surround mode Select a mode other than Stereo
center speakers Input is mono There is no surround information from mono sources
Incorrect configuration Check speaker mode configuration
Stereo or Mono program material Some surround modes may not create rear-channel information
from nonencoded programs
Unit does not respond to Weak batteries in remote Change remote batteries
remote commands Wrong device selected Press the AVR Selector
5
Remote sensor
Ó
is obscured Make certain front-panel sensor is visible to remote or
connect remote sensor
Intermittent buzzing in tuner Local interference Move unit or antenna away from computers, fluorescent lights,
motors or other electrical appliances
Letters flash in the Channel Indicator Digital audio feed paused Resume play for DVD
Display
$
and Digital Audio stops Check that Digital Signal is fed to the Digital Input selected
No picture or on-screen AVR Resolution to Display Select correct Resolution as described
information on the TV screen. is not correct, too high or too low. on page 21 "Resolution To Display"
50 TROUBLESHOOTING GUIDE
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR355 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR355 in the language / languages: English as an attachment in your email.

The manual is 3,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR355

Harman Kardon AVR355 User Manual - German - 58 pages

Harman Kardon AVR355 User Manual - Dutch - 58 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info