502621
3
Zoom out
Zoom in
Previous page
1/4
Next page
SPEAKER AND AUDIO CONNECTIONS
CD PLAYERAM AntennaFM Antenna
L R Optical Coax
REC/IN
PLAY/OUT
AUDIO RECORDER
Step 4. Connect AM and FM antennas as shown above (see page 16).
Step 5. Connect source components, as shown in Figures 4 and 6 and
the Device Connection Options chart on the back of this Guide
(see pages 1617).
AUDIO connections: Right channel (red) on source to right (red)
on AVR, and left channel (white) on source to left (white) on AVR.
DIGITAL AUDIO connections, if available: Choose either coax
(orange) to coax (orange) OR optical to optical for each device.
The Coax 1 input defaults to the DVD player, and the Optical 1 input
defaults to Video 2 (Cable/Sat), but either may be reassigned. Assign
the other digital inputs as appropriate for your equipment (see Step 7).
VIDEO connections: Choose component (Y/Pb/Pr – green/blue/
red), composite (yellow) or S-video (4-pin) for each video source.
Connect the
Video Monitor outputs to your video monitor (TV). If
component video is available, only that monitor output is needed (see
page 17).
The Component
Video 1 input defaults to any of the DVD
,
tuner
,
CD or tape sources
.
The Component
Video 2 input defaults to
any of the Video 1, 2, 3 or 4 sources, or the 6-/8-channel direct
inputs. However, either component video input may be reassigned
using the Input Setup menu. Switch your TV set’s input to match the
type of video used for the currently selected source.
: Make sure the AVR 340 is turned off, then connect the
optional to the DMP connector. Dock your compatible
iPod
®
(not included) in .
Step 6. Plug all components into AC power outlets. The outlets on the back
of the AVR 340 should be used
only for low-current products, such
as CD or DVD players, and the total should not exceed 100 watts.
Basic Receiver Configuration
Step 7. Select digital inputs: If your DVD is connected
to Coax 1, and your
cable or satellite
TV
box (Video 2 source) is connected to Optical 1,
no adjustment is needed. For any other digital-device connections,
use the on-screen Input Setup menu,
or the front-panel Digital Select
and arrow buttons to select digital input (see pages 22,
38).
Step 8.
Select a surround mode: Press the Surround Mode button on the
front panel to select Dolby
®
Pro Logic
®
II – Movie. (You may select
other modes later as you become familiar with the AVR 340; see
pages 23–25 and 35–41.)
Step 9.
Use
to configure and optimize your system:
Plug the EzSet/EQ microphone into the front-panel Headphones
jack (Figure 5). Place the microphone at your normal listening
position. If desired, the microphone may be attached to a standard
camera tripod using the threads on the bottom of the microphone.
Activate EzSet/EQ using the on-screen menu system (see pages
25–27). As EzSet/EQ senses the output of each speaker, you will
hear loud test signals. When the on-screen menu indicates that
setup is complete, your system is adjusted for output levels, delay
times, speaker settings and room equalization. Unplug the micro-
phone and store it for future use.
Step 10.
Y
our system is configured – sit back and enjoy!
/EQ
/EQ
+
The
Bridge
TM
The
Bridge
TM
The
Bridge
TM
Figure 4 – Audio Connections
Dashed lines (––––) indicate coaxial and
optical digital audio connections. Choose
either type (but not both) for each digital
audio source.
The
Bridge
TM
Figure 5 – Connecting EzSet/EQ Microphone
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR340 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR340 in the language / languages: English as an attachment in your email.

The manual is 0,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Harman Kardon AVR340

Harman Kardon AVR340 User Manual - English - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info