ADVANCED FEATURES 31
ADVANCED FEATURES
MENU line and press the Set Button o. If you
have no other adjustments to make, press the
OSD
Button
v to exit the menu system.
Full-OSD Time Out Adjustment
The Full-OSD menu system is used to simplify the
setup and adjustment of the AVR 225 using a series
of on-screen menus. The factory default setting for
these menus leaves them on the screen for 20 sec-
onds after a period of inactivity before they disappear
from the screen or “Time Out.” Time Out is a safety
measure to prevent image retention of the menu text
in your monitor or projector, which might happen if
menus were left on indefinitely. However, some view-
ers may prefer a slightly longer or shorter period
before the display times out.
To change the Full-OSD Time Out, you will need to
make an adjustment in the
ADVANCED
SELECT
menu (Figure 9). To start the adjustment,
press the
OSD Button v to bring the MASTER
MENU
to the screen. Press the ¤ Button q until
the on-screen ¤ cursor is next to the ADVANCED
line. Press the Set Button o to enter the
ADVANCED SELECT menu (Figure 9).
At the
ADVANCED SELECT menu (Figure 9),
make certain that the on-screen
› cursor is next to
the
FULL OSD TIME OUT line by pressing
the
⁄
/
¤
Buttons mq as needed. Next, press
the
‹
/
›
Buttons n until the desired time is
displayed in seconds. Note that unlike most of the
other options in this menu, this is a permanent setting
change, and the Time Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press the
⁄
/
¤
Buttons mq until the on-screen
›
cursor
is next to the desired setting or the
RETURN TO
MENU
line and press the Set Button o. If you
have no other adjustments to make, press the
OSD
Button
v to exit the menu system.