502640
6
Zoom out
Zoom in
Previous page
1/19
Next page
4
Front Panel Controls
ENGLISH
1. POWER BUTTON
Press this button to turn the power
on. Press again to turn the power off
(Stand by). If you connect the other
components to the switched outlet, it
can also be used as a system power
button.
2. HEADPHONE JACK
Stereo headphones can be plugged
into this jack for private listening.
Headphone impedance should be
between 8 ohms and 2K ohms with
best results between 200 and 400
ohms.
3. BASS CONTROL
Modifies the low-frequency sound of
the left and right channels as much as
±10dB. Set this control at a suitable
position for your taste and room
acoustics.
4. TREBLE CONTROL
Modifies the high-frequency sound of
the left and right channels as much as
±10dB. Set this control at a suitable
position for your taste and room
acoustics.
5.BALANCE CONTROL
This control is used for balancing the
relative sound volume of the left and
right channel speakers. Clockwise
rotation reduces the volume from the
left speaker, counterclockwise
rotation reduces the volume from the
right speaker.
6. SURROUND
MODE SELECTOR
Press this button to select the desired
surround mode. The mode is
changed between normal DOLBY
Pro-Logic and DOLBY 3-STEREO.
7. BYPASS SELECTOR
Defeats all surround modes.
8. INPUT FUNCTION
SELECTOR BUTTONS
Press these buttons to select the
desired input source.
9. TAPE MONITOR BUTTON
Press this button to select input from
a tape deck and listen to its monitor
function (with 3 head decks).
10. VCR2 INPUT JACKS
Connect these jacks to the
corresponding output jacks of a VCR
or Camcorder (only playback)
(Yellow: Video, Red/White: Audio).
11. TUNE / PRESET
UP/DOWN BUTTONS
When PRESET and AUTO is not lit,
the Tune/Preset UP/DOWN buttons
will allow you to tune to a station
manually.
12. TUNE / PRESET BUTTON
Press this Tune/Preset button to light
up the preset mode then use the
up/down buttons (11) momentarily to
scan the preset station frequencies.
The receiver stops at each preset
location from 1-30 that has been
entered in memory. Hold the buttons
(11) down to skip through the presets
quickly. In the TUNE mode (selected
by the TUNE/PRESET button (12))
press these buttons to change
selected frequencies.
13. MEMORY BUTTON
Use this button to store an AM or FM
frequency. Press this button and
select one of 30 preset locations to
store the frequency with the UP /
DOWN buttons while the memory
indicator blinks, press MEMORY
again to store preset station.
NOTE: When you store a frequency in
a memory location that already
contains a frequency, you replace the
previous frequency. If your receiver is
disconnected from AC power for
more than about 2 weeks, it loses all
stored frequencies.
14. SEEK STEREO BUTTON
Press this button, “Auto” will
illuminate in the display. Then press
the uP or DOWN button. The tuner
will automatically seek for stations
upwards or downwards in your area
that have enough signal strength to
be listenable. The tuner will stop on
stations until the Seek Stereo button
is pressed again.
15. VOLUME CONTROL
Turn the VOLUME clockwise to
increase the volume and
counterclockwise to decrease it. The
volume of the front, center, and rear
channels is changed at the same
time.
16. DISPLAY WINDOW
This window shows the state of
operation for easier control of the
receiver. It also contains the IR
Remote Sensor.
AVR10 engelsk 11/01/98 10:10 Side 4
6


Need help? Post your question in this forum.

Forumrules
1

Forum

harman-kardon-avr10

Reset search

  • volume control stuck at one output but will still turn Submitted on 28-1-2024 at 13:39

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Harman Kardon AVR10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Harman Kardon AVR10 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info