711508

Hanseatic WQP8-7636 Manual

59
Zoom out
Zoom in
Previous page
1/66
Next page
Page EN-25
Setup or under-worktop installation and connection
2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the enclosed condensation-protec-
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage to
the work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired posi-
tion.
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the adjustable feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.
Water hardness level
Hard water will cause calcification within
the dishwasher. Also, more dishwasher de-
tergent will be required to clean the dishes.
Soft water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to a hardness level of “H3”.
Adjusting the water hardness
level
(13)
(9)
(10)
1. Close the dishwasher door.
2. If the dishwasher is switched on, switch it
off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the button (13) until
LEDs
(9) and (10) flash alternately.
Please refer to the following table for the
relevant water hardness setting:
°dH LED display Setting
… 59 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hanseatic WQP8-7636 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hanseatic WQP8-7636 in the language / languages: English, German as an attachment in your email.

The manual is 4,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info