711493

Hanseatic WQP12-7635 Manual

43
Zoom out
Zoom in
Previous page
1/66
Next page
Page EN-9
Safety
Trip hazard!
An open dishwasher door can quickly
become a trip hazard.
■ Close the door after every use.
■ Only leave the door slightly open to
cool down.
Risk of damage!
Improper handling of the appliance
may result in damage.
■ Never leave the appliance unsuper-
vised for an extended period when
the tap is on.
■ During storms or when going on hol-
iday, always withdraw the mains plug
from the socket and close the water
tap.
■ If there is a risk of frost, loosen the in-
let hose and allow the water to run
off.
■ Only use regenerating salt which is
suitable for dishwashers.
■ Only add dishwasher salt immediate-
ly before the next main dishwashing
cycle, as dishwasher salt which has
overfl owed can damage the seals and
fi lters of the appliance.
■ Immediately remove any spilt dish-
washer salt with a damp towel, as
otherwise the stainless steel surfaces
may be affected.
■ Ensure that the dishwasher detergent
and rinse aid are suitable for the ap-
pliance.
■ Wipe away rinse aid which has over-
fl owed immediately as otherwise it
can lead to excessive foaming which
can compromise the results delivered
by the dishwasher.
■ Do not overload the appliance.
■ Position the upper dish rack at the
highest setting if very tall dishes are
in the lower dish rack, as otherwise the
upper spraying arm will be blocked.
The seals of the door are sensitive to oil
and grease.
■ Do not apply grease to the door seals.
The door seals can be damaged by un-
suitable cleaning agents.
■ Do not use harsh, aggressive, sol-
vent-based or abrasive cleaners.
The appliance is designed for a water
pressure of 0.4-10 bar (0.04-1.00 MPa,
40-100 N/cm
2
).
■ If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■ Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■ Ensure that the inlet hose is not
kinked and is carefully connected.
■ Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist.
■ Do not use old or previously installed
inlet or outlet hoses.
■ The outlet hose must have a mini-
mum diameter of 40mm so that the
water can be pumped away unhin-
dered.
■ Do not attach the outlet hose your-
self, have it installed by a special-
ist plumber. Have the outlet hose
checked regularly for damage or
kinks.
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hanseatic WQP12-7635 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hanseatic WQP12-7635 in the language / languages: English, German as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info