711516

Hanseatic WQP12-7609H Manual

57
Zoom out
Zoom in
Previous page
1/64
Next page
Page EN-25
Installation, connection and commissioning
Having the outlet hose
connected
NOTICE
Malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
■ Make sure that the waste water can
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40mm.
■ Ensure that there are no kinks or dam-
age to the outlet hose.
■ Make sure that the end of the hose is
not submerged in the pumped water.
■ Do not extend the outlet hose or re-
place with another drainage pipe.
Ø ≥ 40 mm
max. 1 m
You can connect the outlet of the waste water
hose in two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (si-
phon) of your washing/dishwashing basin.
Specific technical measures are required
for this. For this reason, only plumbing ex-
perts or members of our service team may
connect the outlet hose (see see EN-30).
The outlet hose must be a maximum of 1 m
above the floor.
Connecting the inlet hose
NOTICE
Risk of damage!
The dishwasher is designed for a water
pressure of 0.4 to 10bar (0.04 to 1.0
MPa, 40 to 100 N/cm²). Water must al-
ways be able to run freely into the dish-
washer, otherwise this can damage the
appliance.
■ If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■ Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■ Ensure that the inlet hose is not
kinked and is carefully connected.
■ Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist (see „Service“
on page EN-30).
■ Do not use old or previously installed
inlet or outlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
… 57 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hanseatic WQP12-7609H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hanseatic WQP12-7609H in the language / languages: English, German as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info