513861

Hannspree ST28 Manual

38
Zoom out
Zoom in
Previous page
1/50
Next page
38
English
6. During the setting process, only digit keys ‘0’ through ‘9’ are valid inputs, while
other buttons are deemed invalid and do not affect the code setting. For example,
inputting “02” then pressing RETURN does affect the “02” already input.
6.1.3 Searching Codes
If the desired electronic equipment code for setting can not be found on the list in the
appendix, try to use the code-searching function with operating procedures as
follows:
1. Press the corresponding electronic equipment button. The indicator light will come
on for 2 seconds then it goes off; after 3 seconds, the indicator light will come on
again, showing that the setting mode has been entered.
2. Hold the electronic equipment button while pressing POWER, then input mode
codes 9-9-9 in sequence. If the indicator light does not come on again after going off,
the code setting is valid; otherwise the indicator light comes on again after going off
for 2 seconds, prompting user to re-enter mode codes.
3. If setting is successful, the electronic equipment code-searching state is entered
upon releasing the electronic equipment button. The POWER signal of all
manufacturers’ codes under the current electronic equipment mode is then
transmitted automatically every 5 seconds.
4. During search, the indicator light will flash when the POWER signal of each
electronic equipment is transmitted. When one cycle of code-searching is complete,
the indicator light will come on for 2 seconds before going off, exiting search mode
automatically.
5. Pressing CH+/CH- during search transmits the next/previous electronic equipment
POWER signal without waiting for 5 seconds, and resets the timer to trigger another
5 seconds interval.
6. Pressing POWER during search exits search mode without saving the new
electronic equipment code; pressing OK during search saves the most recently
searched electronic equipment code and then exits search mode.
7. Buttons other than POWER, OK, and CH+/CH- are not functional during search.
6.1.4 Setting Volume Lock
Operating procedures are as follows:
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hannspree ST28 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hannspree ST28 in the language / languages: English as an attachment in your email.

The manual is 2,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info