495095
13
Zoom out
Zoom in
Previous page
1/35
Next page
9
643
2
7
1
5
8
9
10
( )
O
10
O
10
O
10
ROT
BASS
LEV
O
10
Rise Time
Fast Speed
Slow Speed
[Control Ch]
[Prog. Ch]
[Mod Rx]
[Exp Rx]
[S/F Type]
[P.F.SW Type]
[Dump Out]
[S/F Cont.Code]
Cross Over Freq./ Cabi. Resonance
Fall Time
Brake Time
Rotor Direction /Mic Angle
Character /Mic Distance
FUNCTION
DOWN
UP
VALUE
ROTARY
POWER
ON
AC IN
OFF
REMOTE
STATIONARY
L R
OVER DRIVE
STA
MONO
BASS
& STA
MUTE
NORMAL
MEMORY
L/MONO R
L/MONO R
STATIONARY
& ROT. BASS
ROTARY ROTARY
LESLIE
8PIN
LESLIE
11PIN
REMOTE
to Leslie 2121
MIDI IN
MIDI OUT
LINE OUT
LINE IN
FOOT SW
HORN
ROTOR
LOW
ROTOR
PRESET
1
2
FUNCTION
SELECT
Touch & Hold
[ ]
MIDI
PRESET
SELECT
21
SLOW / FAST
STOP
PRESET
Rotary-Unit
Horn
HORN
LEVEL
VOLUME
21
controls that enhance the organ sounds
The Leslie Control Center is located on the back panel of the Leslie Speaker.
1 - 11-pin Receptacle -
This allows direct connection between the Leslie Speaker and the Hammond XB-Series Organs, using
the cable supplied with the speaker.
2 - 8-pin DIN Receptacle -
This allows direct connection between the Leslie Speaker and the Hammond XB-1 and XM-1
instruments using the special cable provided for this connection.
3 - ROTARY LINE IN -
This allows other instruments to connect to the Rotary channel using standard phone cables.
4 - LINE OUT:
STATIONARY & BASS (L/MONO, R) Jacks -
These allow both the STATIONARY and the LOW
ROTARY channels to be connected to an external amplifier. To connect the STATIONARY UNIT #2121, connect the
L/MONO OUT to INPUT 2.
ROTARY (L/MONO, R) -
This allows the LOW ROTARY channel to be connected to an external amplifier. To
connect the STATIONARY UNIT #2121, connect the L/MONO OUT to INPUT 3.
NOTE: The HORN ROTOR channel has no LINE OUT connection due to the acoustic nature of the sound produced. Using
the HORN ROTORY channel with external amplification requires a microphone.
5 - AC Power Cord Receptacle -
Plug the female end of a grounded AC power cord into this receptacle, and the male end into
an AC outlet.
6 - REMOTE -
When the Leslie 2121 Stationary-Unit is connected, connect to the REMOTE IN with a DCC-2 cable. The power
for the Stationary-Unit can be turned “ON” and “OFF” by the power switch of the Horn-Unit.
NOTE: The REMOTE feature is powered by a battery. The battery’s estimated life is approximately 1000 “turn-ons,”
depending on constancy of electircal current, etc. Do not attempt to replace this battery . Refer all servicing to qualified
service personnel.
7 - FOOT SW -
PRESET -
Allows you to switch between PRESET 1 and 2 using a latching-type Foot Switch.
SLOW/FAST/STOP -
Allows you to control the Leslie rotors using the FS-9H Foot Switch. Each time the Foot
Switch is activated, the rotors will switch between SLOW and FAST. If the Foot Switch is pressed and held for 1
second, the Rotors will Stop.
8 - MIDI IN -
Connects to the MIDI OUT of an organ or keyboard.
9 - MIDI OUT -
Connects to the MIDI IN of an additional Leslie Horn-Unit when 2 units are connected in series. The MIDI IN
from the organ and the FOOT SW signal of the Horn-Unit are merged in the MIDI OUT.
10 - Power Switch ON / OFF -
This allows the Leslie Speaker to be turned "ON" or "OFF."
Continued on next page.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hammond Leslie 2101 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hammond Leslie 2101 in the language / languages: English as an attachment in your email.

The manual is 1,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info