723748
12
Zoom out
Zoom in
Previous page
1/19
Next page
6
4.1 Antenna connection / alternative solutions
(Figure D)
Note
To optimise reception, the glass adhesive antenna
should be tted such that it is in contact with the
vehicle body.
If your vehicle’s A pillar is covered with fabric or other
insulating material, t the metal foil there anyway.
Consult a local car workshop regarding the antenna’s
contact with the vehicle body.
Fit the antenna at the edge of the windscreen (preferably
on the passenger side) and connect the metal foil to your
vehicle’s A pillar.
Then connect the SMB connector of the antenna cable to
the antenna input (14) of the adapter.
Note
The included glass adhesive antenna can be replaced
by an alternative antenna solution.
The existing vehicle antenna can continue to be used
with an adapter.
Consult a car workshop or visit www.hama.comfor
suitable accessories.
4.2 Mounting
Warning Risk of injury
Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are not
blocked or restricted.
Do not allow yourself to be distracted by the product,
for example when driving a vehicle or operating sports
equipment. Always pay attention to the surrounding
trac and your environment.
Note
Before mounting the holder, check the installation
options in your vehicle. If in doubt, consult the manual
for your vehicle or contact the manufacturer.
Strictly avoid using undue force when using the
product or during installation.
A) Mounting to ventilation grille
Fit the mounting adapter for ventilation apertures to the
back of the product. (Figure A)
Now insert the device into the ventilation grille.
The peg for the mount in the ventilation grille can be
turned 360° so that you can adjust alignment.
B) Mounting using the adhesive pad
Note Mounting surface
Please note that the selected mounting surface (e.g.
dashboard) should be free of dust and grease. Use a
suitable cleaning agent from a specialised dealer to
clean the surface.
Fit the mounting adapter with the adhesive pad to the
back of the product (Figure B).
Clean the surface to which the adhesive pad is to be
axed.
Now remove the protective lm from the adhesive pad
and mount the adapter on the chosen surface.
4.3 Connection
Note
Only use original accessories (or accessories approved
by Hama), to prevent damage to the product.
Connect the supplied USB charging cable to the USB port
(16) of the device.
Connect the unused plug on the USB cable to a 12 V
socket of your vehicle.
4.4 Switching on / Standby / Initial setup
Switching on the product
Press and hold [
](2) for about 3 seconds to switch on
the device.
Switching off the product
Press and hold [
] (2) for about 3 seconds to activate
the standby mode.
Note
To switch off the radio completely, disconnect it from the
power supply.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hama CDR70BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hama CDR70BT in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hama CDR70BT

Hama CDR70BT User Manual - German - 19 pages

Hama CDR70BT User Manual - French - 19 pages

Hama CDR70BT User Manual - All languages - 84 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info