817592
18
Zoom out
Zoom in
Previous page
1/36
Next page
EN
6-Daily use
18
6.11 Interrupt / cancel wash programme
To Interrupt a running programme press gently “Start/Pause“. The LED above the button
is fl ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Touch “Start/Pause” button to interrupt the running programme.
2. Touch “Power“ button for about 2 seconds to switch the appliance off .
3. Touch the “ Power “ button to turn on the appliance, run programme Spin and select
“ no Speed “ (speed lights are off ) to drain the water.
4. After closing the programm to restart the appliance,select a new programme and start it.
1. At programme cycle end  is displayed.
2. The appliance switches off automatically.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. Turn off the water supply.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the “Spin” programme.
3. Touch the “Anti-crease“ button and “Speed” button at the same time for about 3
seconds. “ ” will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. “ ” will
be displayed.
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;  is displayed
Note: Standby-mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the program or at the end of program. The display switsches off .
This saves energy. To interrupt the standby mode touch “ Power“ button.
6.10 Start wash programme
Touch “Start/Pause“ button (Fig. 6-8) to start. The LED
of the “Start/Pause“ button stops ashing and lights
up continuously. Appliance operates according to pre-
sent settings. Changes are only possible by cancelling
the programme.
3-14
6-8
6.12 After washing
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haier HW80-BD14979U1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haier HW80-BD14979U1 in the language / languages: English as an attachment in your email.

The manual is 3.1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haier HW80-BD14979U1

Haier HW80-BD14979U1 User Manual - German - 36 pages

Haier HW80-BD14979U1 User Manual - Dutch - 36 pages

Haier HW80-BD14979U1 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info