817589
24
Zoom out
Zoom in
Previous page
1/32
Next page
9-Troubleshooting EN
24
Should the error messages reappear even after the taken measures, switch off the appli-
ance, disconnect the power supply and contact the customer service.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be activated
for 90 seconds. If that elimination of foam fails up to 3 times, programme ends without spinning.
Note: Unlock the door
When the washing machine in a safe state (under the water level below the window
along a certain distance, barrel temperature below 55 °C, the inner barrel did not turn),
may unlock the doors of the machine operation
Problem Cause Solution
Excessive foam fl oats
drum and/or deter-
gent drawer.
Detergent is not a appropriate. Check detergent recommen-
dations.
Excessive use of detergent. Reduce amount of detergent.
Automatic adjust-
ment of washing time.
Washing programme duration will
be adjusted.
This is normal and doesn‘t af-
fect functionality.
Spinning fails. Unbalance of laundry. Check machine load and laundry and
run a spinning programme again.
Unsatisfactory
washing result.
Degree of pollution does not agree
with selected programme.
Select an other programme.
Detergent quantitiy was not suf-
cient.
Choose the detergent acc. to
the degree of pollution and acc.
to manufaturer specifi cations.
Maximum load has been exceeded. Reduce loading.
Laundry was unevenly distributed
in the drum.
Loose the laundry.
Washing powder
residues are on the
laundry.
Insoluble particles of detergent can
remain as white spots on the laun-
dry.
Perform extra rinse.
Try to brush the points from
the dry laundry.
Choose an other detergent.
Laundry has grey
patches.
Caused by fats such as oils, creams
or ointments.
Pretreat the laundry with a
special cleaner.
9.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be re-
sumed.
If a power failure cuts an operating wash programme
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door - Danger of burns! Water level has
to be lowered as described in “Pump lter”. Not till then
pull lever (A) beneath service ap (Fig. 9-1) until door
is unlocked by a gentle click. Afterwards refi x all parts.
9-1
A
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haier HW80-B14939 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haier HW80-B14939 in the language / languages: English as an attachment in your email.

The manual is 3.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haier HW80-B14939

Haier HW80-B14939 User Manual - German - 32 pages

Haier HW80-B14939 User Manual - German - 32 pages

Haier HW80-B14939 User Manual - Dutch - 96 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info