711349
20
Zoom out
Zoom in
Previous page
1/23
Next page
20
WATER INLET VALVE AND INLET VALVE FILTER
To prevent blockage to the water supply by ingress of foreign substances, clean the water inlet valve and
inlet valve filter regularly
.
MOVING THE MACHINE
MAINTENANCE OR SERVICE WASH
If the machine is to be moved to a distant location, replace the transportation bolts
removed before installation to prevent da
mage as
shown below
Remove the back cover1.
Remove the blanking plugs.
2.
Insert the synthetic stabilisers and the transportation bolts.3.
Tighten the bolts with a spanner .4.
Replace the back cover
.
5.
LONG PERIODS OF DISUSE
If the washing machine is left idle for a long period, pull out the electrical plug and turn off the water supply
Open the was her door to
prevent formation of moisture and odours. Let the door open while not used.
Delay
Power
Heavy
Sport wash
Quick
Spin
Wash
Rinse
Spin
Temp.
Speed
Auto
Silk
Wool
Synthetic
Memory
Cotton
Start/Pause
Pressand hold 2seconds
to set door unlocked
Delicate
Silent
Self-clean
Strongwash
Pre-wash
Soak
MANUALLY OPENING THE WASHING MACHINE DOOR
To add clothing when washing after the wash program has started or after a power cut, you want to remove the
clothing, do the following steps.
1. Make sure the level of water in drum must under the lowest edge of the door window,
2. The temperature of water is not over 50°C
3. The machine is switch off at the power supply so the drum cannot turn.
4. Disconnect the drain hose and place the open end in a bucket lower the end so that the
water in the washing machine drains out.
5. Re-connect the drain hose to the drain system.
6. Open the filter access door at the bottom of cabinet, you can see a ring pull handle. Gently pull the sprung loaded
handle down, and pull the door at the same time to open it.
7. You can add or remove the clothing. Caution, the clothing will be very wet.
8. Close the filter door.
A maintenance wash is recommended to be done to clean the washing machine out by running a high-temperature (90°C Cotton)
program. This is especially recommended if you do a significant number of low temperature washes a month. The high temperature
kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves putting the washing machine on the hottest
wash (90°C Cotton Wash) with only the detergent inside - and no laundry. If you normally use a washing machine detergent that
doesn't contain bleach, then buy some detergent that does, and use it for your maintenance washes. This will help kill off bacteria
and prevent black mould and grease. Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach
(like Domestos) in the washing machine this will damage the machine. There are certain types of bleach example oxygen bleaches
like “Vanish” that are appropriate for laundry. To check if your washing machine is being badly affected, carefully examine the inside
of the door seal for slime. Pull the lip in front of the drum and look underneath on lip of the tub as it can accumulate a slime, which
causes smells, and rots the seal.
USING THE APPLIANCE
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haier HW60-B1286 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haier HW60-B1286 in the language / languages: English as an attachment in your email.

The manual is 6,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info