Manual Haier HF-136A (page 12 of 52) (English, German, Dutch, French, Italian, Spanish)

42176

Zoom out

Zoom in

1/52

This User’s Manual is applicable to a variety of

models and there may be slight changes in certain

aspects from model to model.

1. Environmental Protection and

Proper Disposal

Package materials

The appliance is packaged in a way to prevent damages

during transportation. Recyclable materials are used.

The packing box is made of corrugated board / cardboard

(mainly from recycled paper).

y Polystyrene parts (CFC-free foamed polystyrene)

y Linings and polyethylene bags

y Polypropylene straps

All these valuable materials may be taken to a waste

collecting center and used again after adequate recycling.

All waste materials should be disposed properly.

2. Location

Make sure the refrigerator is kept upright during handling.

If an inclination is required, it should not exceed 45

degrees. Otherwise the appliance may get damaged

resulting not only in compromised refrigeration

performance.

To avoid product damage or personal injury, the

refrigerator should be unpacked by two persons after it is

located in a previously selected position.

Before installation, make sure the refrigerator has no

visible exterior damage.

When handling the refrigerator, do not lift it by holding the

worktop, to prevent any damage to the refrigerator.

Do not start up a refrigerator that is damaged.

Check the refrigerator carefully for:

y Damaged package due to inappropriate handling

during transportation

y Damage in the exterior

y Damage in power cord / plug

Any doubt, please contact Customer Service for a

thorough checkup of the appliance.

Take necessary measures to prevent leakage of

refrigerant at the start-up of refrigerator that may result in

environmental pollution.

3. Installation

a) Remove all package materials.

b) Remove items in the refrigerator.

c) Make sure to remove film and tape on the cabinet

and the door.

d) Remove polystyrene chips (if any) around the

refrigerator.

e) Take out accessories and literature in the refrigerator.

f) Clean the inside of the refrigerator with lukewarm

water and vinegar and then dry it with a soft cloth.

g) Use the spanners supplied to adjust the leveling leg

to ensure the refrigerator is stable.

Do not use detergents, sharp or pointed instruments

or soda-based cleansers to clean the refrigerator.

y Before installation, make sure the refrigeration system

is free of any damage.

y The refrigerator should be used for its intended

purpose only.

y The refrigerator should be positioned on the solid and

even floor to ensure refrigerant circulation and

refrigerating performance.

y If possible, position the refrigerator in a cool and dry

well ventilated room.

y Do not expose the refrigerator to direct sunshine and

make sure the ambient temperature is not extremely

high.

y Keep the refrigerator from a heat source, such as

heating system, oven or cookers. Otherwise the

compressor will operate more frequently resulting in

extra power consumption.

If the refrigerator will be placed near a heat source, it is

recommended to install a thermal barrier between the

refrigerator and the heat source (asbestos is prohibited)

or maintain adequate space between the refrigerator and

the heat source as follows:

Cooker or electric stove 3 cm

Radiator or oven 30 cm

Another refrigerator 2 cm

Do not place any radiating apparatus, such as microwave

oven or roaster, on top of the refrigerator.

Make sure the air vent is not obstructed.

Never unplug the refrigerator by pulling on the power cord.

Always grip the plug firmly and pull it straight out from the

outlet.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Haier HF-136A in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Haier HF-136A Manual

Product: