47
APPENDICES
Troubleshooting
No display
Check if the batteries are correctly placed.
Put the handset in the base or charger to load the batteries.
Remove the batteries from the handset, and place them back carefully.
The batteries are empty
Check if the batteries are correctly placed.
Clean the charging contacts of handset and base. Charge the batteries.
The display shows a limited charge of the batteries and the handset gives a
warning signal:
Load the batteries of the handset. Replace the batteries when the autonomy
becomes too short.
The handset does not find the base
You are out of range, stand closer to the base.
Check the power supply of the base.
Register the handset as described in this manual.
Remove the batteries from the handset, and place them back carefully.
Pull the base's power supply plug, and plug it in again.
No dialing tone
Check if the telephone cable is well connected to the base and to the wall
plug.
Use the delivered cable.
Adjust the volume of the handset to a higher level.
Dialing a number impossible
The chosen telephone number is blocked.
The keypad is locked.
Reset the settings of the handset back to the defaults.
