564789
23
Zoom out
Zoom in
Previous page
1/34
Next page
23
5. Shutoff flue gas temp. in Heating mode too
low (21)
Cause:
Temperature fell below the minimum
temperature in Heating mode operating
status
The following circumstances might lead to this:
No pellets present
The screw conveyor is not rotating, it is
jammed, the screw conveyor motor is
defective or the chute is not clear
The required combustion air cannot be
supplied to the stove e.g. via a vapour
extractor hood that is located in the
vicinity of the installation site and is
switched on.
Room too airtight required combustion
air cannot be replenished in the room
Suction filter dirty
Burner dirty
Poor seals on the pellet stove (door,
seals)
Flame temperature sensor defective
Flue gas temperature sensor defective
Correction:
Refill pellets
Check that the chute between the pellet
tank and the burner is clear.
Clean the burner and suction filter.
Check whether there is a vapour
extractor hood present and whether it is
in operation
Make sure for instance that a window is
left open a crack to supply the required
combustion air
Contact the service engineer
6. Shutoff flue temp. in Heating mode too high
(22)
Cause:
The highest permitted flue gas
temperature was exceeded
The following circumstances might lead to this:
Too much fuel is being supplied to the
burner
Flue gas temperature sensor defective
Correction:
Contact the service engineer
7. Shutoff, combustion chamber door open (6)
or (9)
Cause:
The door is open for longer than 1 minute
during operation
The damper at the bottom of the door is
not in the right position
Cable broken in the electric wiring to the
door contact switch
The connector has come out on the door
contact switch or on the central unit
Correction:
Close the door
Move the damper at the bottom of the
door to the right position so that the
switch is operated when the door is
closed
Check door contact switch, cable and
connector
8. Flue gas sensor interruption (7)
Cause:
Flue gas temperature sensor defective or
not connected
Correction
Contact the service engineer
9. Flue gas sensor short circuit (8)
Cause:
Flue gas temperature sensor defective
Correction:
Contact the service engineer
10. Room temperature sensor interruption (11)
Cause:
Room temperature sensor defective or
not connected
Correction:
Contact the service engineer
11. Room temperature sensor short circuit (12)
Cause:
Room temperature sensor defective
Correction:
Contact the service engineer
12. Flame temp. sensor interruption (23)
Cause:
Flame temperature sensor defective or
not connected
Correction:
Contact the service engineer
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haas-Sohn PELLETTO 417.08 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn PELLETTO 417.08 in the language / languages: English as an attachment in your email.

The manual is 3.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn PELLETTO 417.08

Haas-Sohn PELLETTO 417.08 Usermanual and installation guide - German - 34 pages

Haas-Sohn PELLETTO 417.08 User Manual - French - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info