Floor protection slabs (support slabs) are available from our
accessories program and can be ordered from your specialist
stove dealer if required.
Floor protection slabs (support slabs) are available from our
accessories program and can be ordered from your specialist
stove dealer if required.
5. wood stove operation
The wood stove must only be heated by adults. Ensure that
children never stay alone around the chimney stove. (Do not
leave the wood stove without supervision for any length of
time). The wood stove must only be used in accordance with
this Operating Manual.
Please observe the safety instructions shown in Chapter 2.
5.1. Suitable fuels
The stove is suitable for low-smoke fuels. The fuels approved
for combustion are listed on the Equipment Sheet.
Note! Wood is not a slow-combustion fuel so that continuous
heating of the fireplace with wood overnight is not possible.
Note:
Never use waste such as wallpaper, chipboard offcuts, plastic
materials or impregnated wood for heating!
5.2. Initial start-up of your wood stove
Prior to initial start-up remove any adhesive labels and all
accessory components from the ash pan or the firebox, this also
applies to any transport locks that may have been used. On
models with draft baffle plates made of ceramic fibre or
vermiculite please check if these plates are located in their
anchorages (these could have slipped from their position as a
result of the transport or the installation of the chimney stove).
Otherwise these plates must be carefully hooked into position
(see Equipment Sheet).
Before initial operation of the power supply still has to be
plugged into the appropriate slot (see picture).
1.= power cable
2.= outside air – pipe fitting
Only for variant i-2100: After connecting the woodstove i-2100
to the power supply system, “AUTO AIR” will appear on the
red LED display continuously (see at the bottom of the front
panel/right side).
Note:
Any smell developing through re-drying of the protective
varnish will disappear after a short time.
5.3. Lighting and heating
Initially place 2 to 3 wood billets (approx. 1.5 to 2.0 kg) on the
firebox floor or grate, uncoated paper, cardboard or a lighting
cube on top, followed by brushwood, firewood or pieces of
briquettes. All existing air control dampers must be fully
opened. After lighting, close the firebox door. After this, set the
air control dampers as specified in the enclosed Equipment
Sheet.
